ET2 E23400 Baritone LED Bath Vanity Instruction Manual
- June 3, 2024
- ET2
Table of Contents
ET2 E23400 Baritone LED Bath Vanity
Before Getting Started
Read the instructions carefully prior to assembling the product.
When you open the package with a sharp tool like a cutter knife, be careful
not to damage the components inside.
Carefully remove all packaging materials and retain for future use.
Keep all hardware parts and packaging out of reach of small children.
Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product in close proximity to where you
intend to position the item.
Do not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.
Risk of suffocation!
Keep any packaging materials away from children.
Lamp
Care Instructions
Carefully read through the instruction sheet before assembly and using the product.
Caution there is a risk of shock. Disconnect from power source before
assembling or cleaning.
Only use the recommended bulb type and do not exceed the maximum wattage as it
could cause fire.
Do not plug the product in if cord is torn or frayed.
Cleaning & Maintenance
On polished finishes, often using talc powder reduces the appearance of fingerprints and other smudges.
For respective shade surfaces, use the appropriate cleansers, i.e. glass cleaner, acrylic polish, and wood polish
Clean with soft cloth and a mild detergent.
DO not use abrasive cleaner.
Periodically (every 90 days) make sure that the screws are fully tightened
Prolonged exposure to heat sources may cause glazing, melting and scorching, or even cause color to fade
contents
Before getting, started, ensure the package contains the following components:
- Prior to installation, install the back plate on the junction box with junction box screws. Drive screws completely to the end of the junction box.
- Put two mounting screws on the back plate then install the base plate and mounting plate.
- Connect supply wires to wires on fixture with wire nuts. Connect white to white, black to black and Green to Green as grounding connection.
- Select the desired Color Temperature by setting the sliding switch to the target CCT(See Fig.2)
- Install the fixture on the mounting plate using the fixture screws provided.
-
Prior to installation, install the mounting plate on the junction box with junction box screws. Drive screws completely to the end of the junction box.
Connect supply wires to wires on fixture with wire nuts. Connect white to white, black to black and Green to Green as grounding connection. -
Select the desired Color Temperature by setting the sliding switch to the target CCT(See Fig.4)
-
Install the fixture on the mounting plate using the fixture screws provided.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>