Exterior Lights Chilham AB-HB-NB Commercial Bollard Black Die-Cast Aluminium Instruction Manual
- June 9, 2024
- Exterior Lights
Table of Contents
Exterior Lights Chilham AB-HB-NB Commercial Bollard Black Die-Cast
Aluminium
DIMENSION
Optional mounting
WEIGHT
INSTALLATION
WIRING
MOUNTING
Operation & Maintenance
Failed light source should be replaced promptly or the circuit switched off to avoid possible damage to control gear.
Important – Safety
Before carrying out any servicing on these luminaires, ensure that the mains
supply is fully isolated.
Disconnect the luminaire before insulation testing of the installation.
Ensure no cables / wires are trapped during bollard assembly.
-
Care must be taken when removing / fitting bollard head to prevent LED damage.
-
Any alterations to the luminaire, will need to the confirmed with Gemma Lighting. If alterations have been carried out to the luminaire without confirmation the luminaires safety & warranty will be at risk.
-
Tested to BS EN 60598
-
For All Standard / All Dali / All AstroDim: ta -20OC … 25OC For All : ta 0OC … 25OC
-
Between the control conductor and low voltage supply, the maintained insulation level is basic.
CAUTION: The light source contained in this luminaire shall only be replaced by the manufacturer or a service agent or a similar qualified person.
Do not stare at the operating light source
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>