Chug C8926LS Earbud Case Charging Pad User Manual
- June 5, 2024
- Chug
Table of Contents
Chug C8926LS Earbud Case Charging Pad
Quick tips
- Alignment matters – centering the device on the charging surface ensures the fastest and most efficient charge
- Protective cases, as well as some materials, can interfere with the ability to charge
included
- Wireless charger
- USB-A to Micro-USB charging cable (note: charging cable does not transfer data)
indicators
- Solid Red – Ready to charging your device
- Solid White – Charging your device
- Flashing Red and White – Foreign object detection, pieces of metal or other materials may cause overheating and damage your charger or earbud case. Remove them immediately
charging
-
Place the charger on a sturdy flat surface
-
Using the Micro-USB cable provided, plug the cable into a USB power supply of
DC 5V 2A minimum warning: please use UL compliant power supply -
Place your QI-enabled device onto the wireless charger and align the device with the center of the charging surface or the device will not charge
-
Charge time will vary by device
troubleshooting
-
Double-check that the Micro-USB cable is plugged in and DC 5V 2A power source is working
-
Certain protective cases may interfere with wireless charging. Remove the protective case for best results.
-
Double-check the placement of the device on the wireless charger. For best results, the center of the device should be on the center of wireless charger
need some help?
Can’t get it to charge? Just have a question? -
Keep the charger away from heat and direct sunlight
-
Do not modify or repair this device
-
Do not use in high temperatures or extreme weather
-
Do not use chemical detergents to clean your device, use a soft dry cloth
-
Immediately unplug the device from the power source if it gets wet
FCC ID: 2AO23-C8926LS Model: C8926LS Input: DC 5V 2A Output: 5W Max Made
in China
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
Target Corp. Mpls. MN, 55403 Phone:
612-304-6073
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>