TESY CB Oil Filled Radiator User Manual

September 21, 2024
TESY

TESY CB Oil Filled Radiator

This product is only suitable for well insulated spaces or occasional use.

GENERAL OPERATION AND SAFETY INSTRUCTIONS

WARNING!

  • Read carefully this manual before using the oil-filled radiator. Keep this manual for further reference. If the appliance is to be acquired by a new owner this manual should also be submitted!

  • CAUTION : Children under 3 years of age should be kept away from the appliance unless they are under constant supervision.

  • Children from 3 to 8 years of age are allowed to operate the on/off button ONLY, provided that the appliance is installed and ready for operation and such children have been supervised and instructed in safe operation of the appliance and they understand all related risks.

  • Children from 3 to 8 years of age MUST NOT: connect the plug to power sockets, make adjustments, clean it or carry out user maintenance operations.

  • This appliance can be used by children older than 8 years of age and by people with reduced physical, sensor and mental capabilities, as well as by people with insufficient experience and knowledge provided they are supervised or instructed in safe operation of the appliance and understand the related risks. Children should not be allowed to play with the appliance. Cleaning and user maintenance operations must not be carried out by children without supervision.

  • CAUTION : Some of the appliance parts may get very hot during operation and thus cause burns to users. In case there are children and vulnerable people in the room, special attention should be paid.

  • WARNING : In order to avoid overheating do not cover the appliance!

  • You should not position radiator in immediate proximity to a socket outlet, especially below it!

  • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

  • Take the radiator out of the packing box and remove all packing material stuck between fins. Check if radiator is not damaged during transportation and if its power cord is intact.

  • Before connecting oil-filled radiator to the main electricity system check if rated voltage shown on the technical information plate corresponds to the voltage of the electricity system at your home (office). The appliance is intended to be used with the voltage that is shown on its technical information plate. It is obligatory to connect the radiator only to grounded socket-outlets.

  • Appliance has to be operated only for the purpose it was intended for, i.e. to provide heating in domestic premises. Every other kind of operation shall be considered incorrect and dangerous. Manufacturer does not take responsibility for damages, caused by improper and unreasonable operation. Non-adherence to these safety measures will render guarantee terms invalid!

  • Do not use the appliance in areas of operation and storage of inflammable substances. Do not use the appliance in highly combustible areas (for example in close proximity to inflammable gases and aerosols) – there is a great risk of explosion and fire!

  • During operation of thermal fan models do not insert or allow to be inserted any objects in the ventilation openings (inlet and outlet). That may lead to damage of the appliance or other hazards.

  • The appliance is not suitable for animal breeding. It is intended for domestic use only!

  • There is a great risk of burning one’s skin in case of touching the surface of the appliance! Do not touch it if the appliance is operating or has been recently turned off – there is a risk of burning!

  • Moving – radiator is to be moved after disconnection of the power cord from the socket outlet and its full cooling down to room temperature! Non-observance of that rule will lead to a great risk of burning and falling of the radiator.

  • Never touch the appliance with wet or moist hands – there is danger for your life!

  • Never pull power cord or the appliance in order to disconnect it from the mains.

  • It is not recommended to use extension, connection-block or other means to supply the oil-filled radiator.

  • With the thermo-fan models do not cover the appliance and do not restrict free air flow to and from inlet and outlet protection grating. Nonobservance of that rule may lead to overheating and fire.

  • Do not cover the appliance during operation! That may cause dangerous rise of temperature inside the radiator.

  • If the appliance is not in order or is not functioning well, turn it off and do not try to repair it yourself. For any kind of repairs search help from authorized service center in you location. There is the place you will have your damaged detail repaired with an original one. Non-observance of this condition will compromise appliance safety operation.

  • If you decide to stop using an appliance of that kind it is recommended to make it unusable by cutting power cord after you have disconnected it from the mains. It is highly recommended all hazards related to the appliance to be secured, especially I there is chance children could use disjointed appliance for play.

  • Never keep the appliance unnecessarily turned-on. Disconnect it from the mains if it is not to be used for a long period of time.

  • In order to avoid dangerous overheating of the power cord it is recommended to unreel it completely from its reel (with the models provided with a reel or power cord compartment).

  • Warning : With thermo-fan models of oil-filled radiators – In order to avoid the risk related to not intentional restart of the thermal protection do not operate oil-filled radiator in combination with a programmer, counter or any other device which automatically turns it on/off because if the appliance is covered or incorrectly positioned there is a risk of fire.

  • Do not use radiator near bath, shower, sink or swimming-pool.

  • Do not use radiator for laundry drying

  • Do not place power cord on the hot surface of the oil-filled radiator!

  • Radiator should always operate in upright position!

  • An appliance with a damaged or not-connected thermoregulator must not be operated.

  • In order to remove the peculiar “new product” smell of your radiator adjust it to maximum power for at least two hours during its first operation.

  • It is normal for the radiator to crackle during its initial operation.

  • It is recommended to leave the radiator for 24 hours after it has been transported into the room that will be heated before using it. At ambient temperature of 5°С or lower it is normal for the radiator to emit “crackling” sounds – this will continue for about 15-20 minutes after it has been turned on.

  • Oil-filled radiator is filled with the exact quantity of thin special oil. Repairs that require opening of oil container should be conducted only by manufacturer or its service agent, which you should contact in case of oil leakage. In event of oil leakage you should immediately connect the authorized service at your location.

  • At decommission of oil-filled radiator observe regulations for oil disposal!

  • Appliance should not be used in rooms smaller than 4 square meters.

TECHNICAL PARAMETERS – SEE ANNEX I CASTOR WHEELS ASSEMBLY

  • Take castor wheels out of their packing. Turn radiator upside down on a carpet or another soft surface in order to protect its body from scratching.
  • Fit the two Castor Wheels onto the radiator by placing the Arc-shaped Brackets between the outermost fins on each side of the radiator.
  • Securely fasten the two Castor Wheels onto the radiator by screwing two Wing Nuts onto each Foot.
  • Important : For the safe operation of your radiator assemble castor wheels as shown on exhibition:

We thank you for choosing oil-filled radiator produced by TESY ltd. This is a product that provides heating in cold winter weather according to customers’ needs for the achievement of comfortable temperature conditions in the premises. If correctly maintained according to the terms of this manual the appliance will provide long-life service.

OPERATION

Turning-on
Put the plug into the socket, turn thermostat knob clockwise and turn the appliance on as follows:

  • Only button (I) is turned-on– light heating – MIN (W);
  • Only button (II) is turned-on – medium heating – MED (W);
  • Both buttons are turned-on – intense heating – MAX (W);
  • Power values of the corresponding levels (MIN(W), MED(W), MAX(W)) are shown in table.
Model MAX(W) MED(W) MIN(W)
1005 1000 W 600 W 400 W
1006 1000 W 600 W 400 W
1506 1500 W 900 W 600 W
1507 1500 W 900 W 600 W
1508 1500 W 900 W 600 W
1509 1500 W 900 W 600 W
2008 2000 W 1200 W 800 W
2009 2000 W 1200 W 800 W
2010 2000 W 1200 W 800 W
2011 2000 W 1200 W 800 W
2012 2000 W 1200 W 800 W
2510 2500 W 1500 W 1000 W
2511 2500 W 1500 W 1000 W
2512 2500 W 1500 W 1000 W
2513 2500 W 1500 W 1000 W
2514 2500 W 1500 W 1000 W
3012 3000 W 1800 W 1200 W
3013 3000 W 1800 W 1200 W
3014 3000 W 1800 W 1200 W

To turn off the appliance turn off the two buttons and take the plug out of the socket outlet.

Concerning ONLY oil-filled radiators with an in-built overturn protection switch (activates in case the appliance falls on the floor)
The radiator has an in-built overturn protection switch. In case of overturning it will switch off the power supply to the appliance. After this kind of switch-off, let the radiator cool down before setting it in upright position. Then it will restore its normal operation.

NOT ALL oil-filled radiators are equipped with this function. You should check if your appliance has this function – by tilting the radiator sideways the indicator lights should switch off; by restoring the appliance back into upright position they should switch on. DO NOT do this test when the radiator is hot – there is a risk of burning.

Thermoregulator adjustment
Power switch and thermoregulator should be set to maximum position until the desired room temperature is reached. Then turn thermoregulator switch in the opposite direction till red light indicator goes down. Thermoregulator may stay in that position after that. Immediately after room temperature falls below thermoregulator value thermal switches are turned on automatically until set temperature is reached. In that way room temperature is steady with minimum energy consumption. If you want to prevent temperature fall in the room below 0 degrees Centigrade adjust thermostat switch in its initial position and turn on the two power buttons.

24-hours timer models (“T”)
Adjust the heating period in the following consequence: • Set the clock to the correct time. If it is 10 o’clock turn the figures dial so that the mark is positioned to the figure of 10.

Note : Turn the figures dial only in the direction indicated with arrows! Adjust the period of operation of the appliance by pushing black keys to the center – every one of them corresponds to 15 minutes period. Sector of the pushed keys will correspond to the period of operation of the radiator in automatic mode every day.

Important : Plug should always be connected to the socket outlet!

  • In order to change programmable period of automatic operation turn black keys backwards and adjust new periods of operation.
  • If you do not want the appliance to operate in programmable mode push all black keys to the center of the figures dial. To turn off the radiator in that case you have to pull the plug out of the socket. In that way unnecessary operation of the timer is avoided.

Thermal fan models (“V”)
Models equipped with a 500W thermal fan offer faster achievement of desired temperature and better ventilation in the room. Thermal fan may function separately or together with oil-filled radiator. Thermal fan is positioned in the bottom part of the front panel of the radiator and is turned on by a switch positioned in that part of the panel. Cold air is sucked through the grating in the front part of the front panel and hot air is released in the room through the grating positioned in the bottom side part of the radiator panel. Desired room temperature with thermal fan operation is adjusted by thermoregulator of the radiator in the above mentioned manner. For the normal operation of the thermal fan it is necessary that air passes unobstructedly through inlet and outlet grating. Electrical device is intended for domestic use in premises with low level of dust pollution. Dust is accumulated after certain period of operation. In is necessary to check periodically level of pollution and if needed to consult the service organization for cleaning.

Note : In case of obstruction of grating of incoming and outgoing air thermal protection is enabled. It turns off heater of the thermal fan. In that case disconnect radiator from the socket outlet, eliminate the cause of the obstruction, wait about 5 minutes and turn on the radiator again. If the thermal fan does not operate connect authorized service at your location. Minimum distance between hot air outlet of the thermal fan and furniture (or other objects) should be 60 cm. We recommend when desired room temperature is achieved to turn off thermal fan and to operate the appliance only in “radiator mode”.

MAINTENANCE

In order to provide long period of operation your oil-filled radiator does not need any kind of special maintenance. Clean radiator with a damp soft cloth. Do not use solvents or abrasive detergents. If necessary use a vacuum cleaner to clean the dust from the radiator!

Instructions for environmental protection
Obsolete electric devices contain valuable materials and therefore they should not be treated as domestic waste! We ask you for cooperation with your active behavior for the protection of resources and nature. We ask you to return your appliance at the organized buy-back stations (if there are any).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals