Maxxima MEW-R150-02 15A 250V Single Receptacle Installation Guide
- September 12, 2024
- Maxxima
Table of Contents
INSTALLATION GUIDE
MEW-R150-02
15A 250V single receptacle
SPECIFICATIONS
Single Receptacle, Side Wire
RATING: 15A 250V
INSTALLATION
- Install in accordance with all electrical codes and standards.
- Switch off power to switch-box and loads.
- Remove insulation from wire approximately 3/8″ to 5/8″. The HOT terminals are the brass screws and the NEUTRAL terminals are the silver screws. Loop the wire around terminal screw as per diagram (or insert solid wire into wire holes). Loop the ground wire around the GREEN terminal screw. Fasten screws securely. Screw terminal and wire hole accept up to 10AWG.
- Mount the device using the long mounting screws provided. Attach wall plate (not included).
- Restore power at the circuit breaker or fuse. See Warning.
WARNING
- TOAVOID RISK OF FIRE, ELECTRICAL SHOCK AND DEATH, SWITCH OFF POWER AT CIRCUIT BREAKER AND ENSURE THAT POWER IS OFF BEFORE STARTING ANY WIRING WORK.
- USE ONLY COPPER WIRES WITH THE DEVICE.
- INSTALL AND USE INACCORDANCE WITH ALL APPROPRIATE ELECTRICAL SAFETY CODES AND REGULATIONS.
WIRING DIAGRAM
WARRANTY
Maxxima extends a 1 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to wormanship and/or materials within the limited warranty period.Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsover beyond sending a free replacement product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>