Maxxima MCL-3141805SN LED Motion Sensor Flush Mount Ceiling Light Instructions

Table of Contents

Maxxima-MCL-3141805SN-LED-Motion-Sensor-Flush-Mount-Ceiling-Light-
PRODUCT

What is the warranty coverage?
- The product comes with a 3-year limited warranty covering defects in material and workmanship. Contact Maxxima for warranty claims.
How do I adjust the detection range?
- The detection range can vary from 10ft to 26.24ft based on the ceiling height. No manual adjustment is needed for this feature.
Can I install this product outdoors?
- This product is designed for indoor use only. Do not install it in outdoor or damp locations to prevent damage.

WARNINGS

Risk of electric shock or fire – Disconnect power at the source before installation.
If you are unsure about the installation or the maintenance of the fixture, please consult an electrician.
Do not make or alter any holes in the wiring enclosure or modify any electrical components.
To prevent wiring damage or abrasion, do not expose wiring to the edges of sheet metal or other sharp objects.

CAUTIONS

The fixture must be wired by the National Electric Code (N.E.C) standards and any applicable local codes or ordinances.
This fixture is designed for use with 120Vac, 50/60Hz only.
Suitable for damp locations.
Supply conductors connecting to the fixture must be rated a minimum of 90° C.
The fixture cannot be used with dimmer switches

Ensure the power has been turned off by switching the circuit breaker to the off position or by removing the fuse from the fuse panel.
Remove the decorative nuts from the metal ring. Remove the metal ring and acrylic lens from the fixture mounting plate.
Using the CCT switch, select the desired color temperature.
Pull the supply wires and housing ground wire out of the junction box.
Connect the hot (black) wire to the black supply wire, the neutral (white) wire to the white supply wire, and the ground (green/bare copper) wire to the green/yellow supply wire using the provided wire nuts shown in figure 4.
Ensure the wires are safely tucked into the junction box and no wires are being pinched or misplaced.
Align the fixture mounting plate over the junction box and, using the supplied mounting screws, secure the fixture to the junction box by tightening the mounting screws. Ensure the screws are tightened in the narrow opening of the key holes.
Place the lens over the fixture mounting plate and then the metal ring over the lens, ensuring the holes in the metal ring are aligned with the metal posts on the fixture mounting plate. Secure with the decorative nuts.
Installation is now complete. Restore power, the light is now operational.

$Maxxima-MCL-3141805SN-LED-Motion-Sensor-Flush-Mount-Ceiling-Light-FIG- $1$$

Detection Range at 10ft Ceiing Height

3 YEAR WARRANTY

Maxxima extends a 3-year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only.
Maxxima will replace any warrantied product with the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period.
Limited warranty is not transferable and applies to the original installation of the Maxxima product.
This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.