MEAN WELL LPL-18 Series Single Output Switching Power Supply Owner’s Manual

18W Single Output Switching Power Supply
LPL- 18 series HM GTIN CODE
MW Search:https://www.meanwell.com/serviceGTIN.aspx

Features:

• 90-132VAC input only
• Fully encapsulated with IP67 level (Note.5)
• Protections: Short circuit/Overload/Over voltage/Over temperature
• Cooling by free air convection
• Class II power unit, no FG
• Pass LPS
• 100% full load burn-in test
• Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices)
• High reliability/Low cost
• 2 years warranty

http://www.meanwell.com.cn/Upload/PDF/LED_EN.pdf

SPECIFICATION

115VAC
MAX. No. of PSUs on 16A CIRCUIT BREAKER| 16 units (circuit breaker of type B) I 27 units (circuit breaker of type C) at 115VAC
LEAKAGE CURRENT| 0.25mA1 115VAC
PROTECTION| OVERLOAD| Above 105% rated output power
Protection type : Hiccup mode, recovers automatically after fault condition is removed
OVER VOLTAGE| 13.8- 16.2V| 27.6- 32.4V| 41.4 – 48.6V
Protection type : Shut off o/p voltage, clamping by Zener diode
OVER TEMPERATURE| Shut down, recovers automatically after temperature goes down
ENVIRONMENT| WORKING TEMP.| -30- +70°C (Refer to “Derating Curve”)
WORKING HUMIDITY| 20 – 90% RH non-condensing
STORAGE TEMP., HUMIDITY| -40 – +80t , 10 – 95% RH
TEMP. COEFFICIENT| ±0.03%It (0 – 50°C)
VIBRATION| 10 – 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY & EMC| SAFETY STANDARDS| EAC TP TC 004,IP67 approved; design refer to UL1310 Class 2,TUV EN60950-1, EN61347-2-13, CAN/CSA C22.2 No. 223-M91
WITHSTAND VOLTAGE| I/P-O/P:3KVAC
ISOLATION RESISTANCE| I/P-0/P:>100M Ohms / 500VDC / 25t/ 70% RH
EMC EMISSION| Compliance to EN55022 (CISPR22) Class B, FCC Part 15, EN61000-3-2 Class A, EN61000-3-3, EAC TP TC 020
EMC IMMUNITY| Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, EAC TP TC 020
OTHERS| MTBF| 6901.7K hrs min. Telcordia SR-332 (Bellcore) ; 1171.8Khrs min. MIL-HDBK-217F (25°C)
DIMENSION| 140`3022(LW*H)
PACKING| 0.175Kg; 70pcs113.3Kgs10.71CUFT

NOTE

1. All parameters NOT specially mentioned are measured at 115VAC input, rated load and 25℃ of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must requalify EMC Directive on the complete installation again. (as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf)
5. Suitable for indoor use or outdoor use without direct sunlight exposure.
6. The ambient temperature derating of 3.5 /1000m with fanless models and of 5 /1000m with fan models for operating altitude higher than 2000m(6500ft).
   Product Liability Disclaimer For detailed information please refer to https://www.meanwell.com/serviceDisclaimer.aspx

Mechanical Specification

Recommend Mounting Direction

Block Diagram

File Name: LPL-18-SPEC 2024-02-19

Documents / Resources

| MEAN WELL LPL-18 Series Single Output Switching Power Supply [pdf] Owner's Manual
LPL-18-12, LPL-18-24, LPL-18-36, LPL-18 Series Single Output Switching Power Supply, LPL-18 Series, Single Output Switching Power Supply, Switching Power Supply, Power Supply
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>