JBL Go 4 Upgrades Bluetooth Speaker User Guide

May 15, 2024
JBL

QUICK START GUIDE

GO4

JBL Go 4 Upgrades Bluetooth Speaker top

WHAT’S IN THE BOX
BLUETOOTH PAIRING

(1) (2)

PLAY
MULTI-SPEAKER CONNECTION

(1)JBL Go 4 Upgrades Bluetooth Speaker A6 (2)

APP

Use the JBL PORTABLE app for speaker configuration and software upgrade.

  JBL PORTABLE

Download on Google Playstore Download on Apple App
store

CHARGING
  1. Low battery
  2. Charging
WATERPROOF DUSTPROOF IP67

JBL Go 4 Upgrades Bluetooth Speaker A10

TECH SPEC
Transducer: 45 mm /1.75″
Output power: 4.2 W RMS
Frequency response: 90 Hz – 20 kHz
Signal-to-noise ratio: > 85 dB
Battery type: Li-ion polymer 3.23 Wh (equivalent to 3.8 V / 850 mAh)
Battery charge time: 3 hours (5 V⎓1 A)
Music play time: up to 7 hours (dependent on volume level and audio

content)
Bluetooth® version:| 5.3
Bluetooth® profile:| A2DP V1.4, AVRCP V1.6
Bluetooth® transmitter frequency range:| 2400 MHz – 2483.5 MHz
Bluetooth® transmitter power:| ≤ 9 dBm (EIRP)
Bluetooth® transmitter modulation:| GFSK, π/4 DQPSK
Product dimensions (W x H x D):| 94.3 x 75.7 x 42.2 mm / 3.7 x 3.0 x 1.7″
Net weight:| 0.192 kg / 0.42 lbs
Packaging dimensions (W x H x D):| 125 x 103 x 56.5 mm / 4.9 x 4.0 x 2.2″
Gross weight:| 0.317 kg / 0.69 lbs
Maximum operation temperature:| 45 °C

  • Factory reset: To restore the factory settings, hold and + for more than 2 seconds.

To protect battery lifespan, fully charge at least once every 3 months. Battery life will vary due to usage patterns and environmental conditions.
Do not expose the JBL Go 4 to liquids without removing cable connection. Do not expose JBL Go 4 to water while charging. It may result in permanent damage to the speaker or power source. Chemicals, salt or “foreign particles” in your pool or the ocean can damage the waterproof seals or harm the connector surface over time if not rinsed off after use. After a liquid spill or rinse, do not charge your speaker until it’s completely dry and clean. Charging when wet might damage your speaker.
When using an external adapter, the output voltage/ current of the external adapter should not exceed 5V/3A.

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.

PA_JBL_GO 4_QSG_Global_SOP_V5

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals