Maxxima MEW-SW235W-02 LED Horizontal Curved Stair Light Installation Guide
- August 21, 2024
- Maxxima
Table of Contents
Horizontal Step Light Installation Guide
MEW-SW235W-02
www.maxximastyle.com
MEW-SW235W-02 LED Horizontal Curved Stair Light
WARNINGS
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unsure about the installation or the maintenance of the fixture, please consult an electrician.
- Do not make or alter any holes in the wiring enclosure or modify any electrical componentry.
CAUTIONS
- The fixture must be wired in accordance with the National Electric Code (N.E.C) standards and any applicable local codes or ordinances.
- Use UL or IEC approved wire only for input/output connections.
- It is imperative that the outlet box be properly grounded.
- Suitable for wet locations.
INSTALLATION INSTRUCTIONS
- Shut off power at the circuit breaker or fuse by switching the circuit breaker to the off postion or by removing the fuse before installation.
- If you are replacing a fixture, remove and disconnect the old fixture.
- Before installation begins select the desired color temperature by moving the switch on the back as shown in figure 1.
- Connect the line voltage to the fixture by connecting the black to the black, white to the white, and the green to the green or bare copper wire using the provided wire nuts as shown in figure 2.
- Once the wires are connected carefully tuck the wires into the junction box and mount the mounting bracket to the junction box using the two provided screws shown in figure 2.
- Ensure the mounting screws are not too tight as this may cause the bracket to bend.
- Align the light with the bracket and then press the light onto the bracket, they will clip together.
- Repeat this process for each step light being installed.
- Installation is now complete restore power and check operation of the fixture(s).
**Note: When using this fixture outside caulk the connection between the faceplate and the wall/step to prevent water from seeping into the junction box.
FIXTURE CARE AND MAINTENANCE
Ensure fixture is at ambient temperature before cleaning.
Clean the lens and faceplate with a non-abrasive cleaning solution.
Do not open the sealed fixture to clean LEDs.
3 YEAR WARRANTY
Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
| info@maxximastyle.com
---|---
| 866-MAXXIMA (629-9462)
| www.maxximastyle.com
| 125 Cabot Court Hauppauge, NY 11788
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>