AES-GLOBAL e-Loop Mini Wireless Vehicle Detection System User Guide
- June 3, 2024
- AES GLOBAL
Table of Contents
Mini Wireless Vehicle Detection System
User Guide
Specifications
| Frequency: | 433.39 MHz |
|---|---|
| Security: | 128-bit AES encryption |
| Range: | up to 50 metres |
| Battery life: | up to 3 years |
| Battery type: | Eveready AA Lithium 1.5Vx 2 (not Included) |
| Important: | Use only AA1.5V Lithium batteries – do not use Alkaline batteries |
e-LOOP Mini Fitting Instructions
Before fitting thee-Loop, you will need to fit the 2xAA batteries and screw
the bottom plate to thee-Loop using the M3 screws supplied.
Ensure all screws are tight.
Step 1- Coding e-LOOP Mini
- Press and hold the CODE button on transceiver until the Red LED illuminates, now release button.
- Press the CODE button on thee-Loop Mini.
The Yellow LED on the e-Loopwill flash 3 times to indicate transmission, and the Red LED on the transceiver will flash 3 times to confirm the coding sequence has completed.
Step 2 –Fitting e-LOOP Mini
(Refer to Diagram on the right)
- Place e-Loop in the desired location and secure base plate into the ground using 2 Dyna bolts (supplied).
NOTE: Never fit near high voltage cables, this can affect the e-Loop’s detection capability.
Step 3- Calibrate e-LOOP Mini
- Move any metal objects away from thee-Loop, including cordless drills.
- Press and hold the CODE button and the Yellow LED will flash once, keep your finger on the button until the Red LED flashes twice.
- Now fit thee-Loop to the base plate using the 4x Hex Head bolts.
After 3 minutes, the Red LED will flash a further 3 times.
Thee-Loop is now calibrated and ready to use.
System is now ready.
Uncolibrate e-LOOP Mini
- Press and hold CODE button and the Yellow LED will flash, keep finger on the CODE button until you see the Red LED flash 4 times.
Now release button and e-Loop is uncalibrated.
sales@aesglobalonline.com
WWW.AESGLOBALONLINE.COM
+44 (0) 288 639 0 693
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>