ET2 E24090 Garden Light Instruction Manual
- August 19, 2024
- ET2
Table of Contents
ltem/Model Number: E24090
Marsh 12-24V LED Garden Light
Lamping | Ampoule:1xLED 5W (Included)
Please consult a qualified electrician prior to install
Made in China
GENERAL 120V INSTRUCTIONS
Before Getting Started
Read the instructions carefully prior to assembling the product.
When you open the package with a sharp tool like a box knife, be careful not
to damage the components inside.
Carefully remove all packaging materials and retain for future use.
Keep all hardware parts and packaging out of reach of children.
Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product in close proximity to where you
intend to install it.
Oo not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.
Risk of suffocation!
Keep packaging materials away from children.
Lamp Care Instructions
Carefully read through the instruction sheet before assembly and using the
product.
Caution there is a risk of shock!
Disconnect from power source before assembling or cleaning.
Switch off, unplug and allow bulb to cool before replacing bulb or cleaning.
Only use the recommended bulb type and do not exceed the maximum wattage as it
could cause fire.
Check the product cord to be sure is free torn or frayed.
Cleaning & Maintenance
On polished finishes, often using take powder can reduce the appearance of
fingerprints and other smudges.
For respective shade surfaces, use the appropriate deansers, i.e. glass
deaner, stone polish, & wood polish.
Clean with soft cloth and a mild detergent. Do not use abrasive or harsh
cleaners.
Periodically (every 90-180 days) make sure that the screws are fully
tightened.
Protonged exposure to heat sources may cause glazing, meitingand scorching, or
even cause color to fade.
Before getting,started,ensure the packagecontains the following components:
-
divide the power cord
-
Put the wire in the big hat.
-
Screw the pin into the lockingcover to pierce the wire and tightenthe large cover
-
Insert the light wirethrough thesmall cap
-
screw the cap into thejoint