rutec 85458 24V LED Power Supply Owner’s Manual

August 15, 2024
rutec

rutec 85458 24V LED Power Supply Owner’s Manual

IMPORTANT SAFETY-/ INSTALLATION INSTRUCTIONS:

General notes for installation

  • Commission a qualified electrician to carry out the installation.
  • Always ensure that the unit is installed in a location with good ventilation to ensure the correct operating temperature.
  • Never connect the cables when the unit is switched on.
  • Check the correctness of the connections and check for short circuits before switching on the voltage.
  • Please do not carry out any repairs yourself. This will invalidate the manufacturer‘s warranty

FOR THE INSTALLATION SITE AND THE PRODUCT MUST BE TAKE INTO ACCOUNT:

The product is only suitable for indoor and outdoor use.
The permissible ambient temperature for the product is -30 to +50° C.

Improper use will destroy the product and we will not accept any guarantee. Therefore, please observe our assembly instructions.

POWER SUPPLY UNITS PER CIRCUIT BREAKER:

LS B 10 B 16 B 25 C 10 C 16 C 25
Stk. 1 2 1 2 3

TECHNICAL DATA:

Input: 100-240V AC
Output: 24V DC, 600W max.
Ambient temperature -30 bis +50°C
Psb: 0.00 W
Pno: 0.45 W
Efficiency at full load: 95 %
Tolerance: ±5 %

TECHNICAL PRODUCT DIMENSIONS:

Dimensions (L x W x H):
300 x 138 x 47 mm

MARKS AND SYMBOLS:

CE-compliant with the applicable European directives

RoHS mark for products that do not contain heavy metals (EC Directive 2002/95/EC)

REACH test mark for products whose chemical components are known, registered and authorised (1907/2006/EG)

Parallel connection Suitable for through-wiring.

Independent operating device

Safety transformer, short-circuit proof

Safety extra-low voltage

Protection class I (protective conductor connection)

Protected against temporary submersion

DISPOSAL

Dispose of electrical and electronic equipment in an environmentally sound manner. For more information, contact your local authority

DESCRIPTION:

GENERAL INFORMATION:

The LED power supply unit 85458 is a non-dilemma power supply on the primary side, which outputs a rectified constant voltage of 24V DC on the secondary side for a maximum power consumption of 600W.

WIRING DIAGRAM:

INSTALLATION:

  • First connect the LED strip to the secondary side of the power supply unit. Pay attention to the correct polarity + (anode) and – (cathode).
  • Connect the primary side of the LED power supply unit to the 230 V AC mains voltage in a de-energised state, observing the five safety rules.
  • Check that the input and output cables have been connected correctly before switching on the power to operate the LED power supply.

INSTALLATION NOTE:

We recommend a flexible cable and a maximum connection length of 4.0 m for the secondary connection. With a longer connection cable, design the cross-section of your cable so that the expected voltage drop is ≤0.2V DC to prevent a brightness or colour shift in the LED strip.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals