rutec 85267 12V LED Power Supply Instruction Manual
- August 10, 2024
- rutec
Table of Contents
rutec 85267 12V LED Power Supply
IMPORTANT SAFETY
General notes for installation
- Commission a qualified electrician to carry out the installation.
- Always ensure that the unit is installed in a location with good ventilation to ensure the correct operating tempe-rature.
- Never connect the cables when the unit is switched on.
- Check the correctness of the connections and check for short circuits before switching on the voltage.
- Please do not carry out any repairs yourself. This will invalidate the manufacturer‘s warranty.
FOR THE INSTALLATION SITE AND THE PRODUCT MUST BE TAKE INTO ACCOUNT:
The product is only suitable for installation in dry indoor areas. The
permissible ambient temperature for the product is -10 to +40° C. Improper use
will destroy the product and we will not ac-cept any guarantee. Therefore,
please observe our assem-bly instructions.
POWER SUPPLY UNITS PER CIRCUIT BREAKER:
- LS B10 B16 B25 C10 C16 C25
- Stk. 8 13 20 13 22 34
TECHNICAL DATA
| Input: | 100-240V AC, 50/60Hz |
|---|---|
| Output: | 12V DC, 12W max. |
| Ambient temperature | -10 bis +40°C |
| Psb: | 0.00 W |
| Pno: | 0.18 W |
| Efficiency at full load: | 81 % |
| Tolerance: | ±5 % |
TECHNICAL PRODUCT DIMENSIONS
Dimensions (L x W x H):
- 86 x 45 x 26 mm 86
MARKS AND SYMBOLS
- CE-compliant with the applicable European directives
- RoHS mark for products that do not contain heavy metals (EC Directive 2002/95/EC)
- REACH test mark for products whose chemical components are known, registered and authorized (1907/2006/EG)
- Parallel connection Suitable for through-wiring.
- Independent operating device
- Safety transformer, short-circuit proof
- Safety extra-low voltage
- Protection class II (double or reinforced insulated housing)
- Protection against contact with foreign bodies ≥20mm.
- For indoor use only
DISPOSAL
- Dispose of electrical and electronic equipment in an environmentally sound manner. For more infor-mation, contact your local authority.
DESCRIPTION
GENERAL INFORMATION
The LED power supply unit 85267 is a non-dimmable power supply on the primary
side, which outputs a rectified constant voltage of 12V DC on the secondary
side for a maximum power consumption of 12W.
WIRING DIAGRAM
INSTALLATION
- First connect the LED strip to the secondary side of the power supply unit. Pay attention to the correct polarity + (anode) and – (cathode).
- Connect the primary side of the LED power supply unit to the 230 V AC mains voltage in an energized state, observing the five safety rules.
- Check that the input and output cables have been connected correctly before switching on the power to operate the LED power supply.
INSTALLATION NOTE:
We recommend a flexible cable and a maximum connection length of 4.0 m for the
secondary connection. With a longer connection cable, design the cross-section
of your cable so that the expected voltage drop is ≤0.2V DC to prevent a
brightness or colour shift in the LED strip.
85267_LED-Netzgerät 12V12W IP20_BA_05/2024
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>