SATCO S13145 HID Replacement LED Color Selectable Bulb Installation Guide
- August 5, 2024
- SATCO
Table of Contents
SATCO S13145 HID Replacement LED Color Selectable Bulb Installation Guide
HI-PRO LED SMART PORT LAMPS
Models: S13140, S13141, S13142, S13143, S13144, S13145
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
- Luminaire wiring and electrical parts may be damaged when drilling for installation of LED retrofit. Check for enclosed wiring and components.
- LED Retrofit installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
- Install this lamp only in luminaires that have the construction features and dimensions shown in the photographs and/or drawings and where the input rating of the retrofit does not exceed the input rating of the luminaire.
- Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Disable all power to the Luminaire. The lamp holder must be disconnected from the wiring to the ballast, capacitor, or ignitor. Verify that voltage does not exceed 277V AC. Please see “Wiring Diagram”.
- Failure to follow instructions can result in a damaged product and will void warranty. It could also result in an electric shock or fire.
IMPORTANT:
- Added weight of the device may cause instability of a free-standing portable luminaire.
- Installers should not disconnect existing wires from lampholder terminals to make new connections at lampholder terminals. Instead installers should cut existing lampholder leads away from the lampholder and make new electrical connections to lampholder lead wires by employing applicable connectors.”
WIRING DIAGRAM:
INSTALLATION:
Step 1: Turn off the power before installation.
Step 2: Remove the old Ballast, Capacitor and Ignitor (if existing).
Step 3: Make sure Alternating Current Wires connect to the socket directly. Reattach or replace ground lead (if necessary).
Step 4: Select color temperature on lamp (Fig. A).
Step 5: Screw the LED lamp into the corresponding socket. Attach retrofit label to luminaire.
Optional Hi-Pro Intelligent Interface Accessories:
© Copyright 2020 Satco Products, Inc. 9/20