ESR Qi2 MagSlim Power Bank User Guide
- July 31, 2024
- ESR
Table of Contents
Tech Made Easier
Qi2 MagSlim Power Bank
Tap and charge Adjustable kickstand Long press for 3 seconds to power off USB-C charging port
Digital Display Screen
| Short press for 1 second to power on
---|---
| Wireless charging output
| USB-C input
| Long press for 3 seconds to power off
| USB-C output
| Error
Note
- The power bank only supports magnetic attachment with a caseless iPhone with MagSafe, an official MagSafe case, an ESR HaloLock™ case, or a standard case with a HaloLock™ Universal Ring. It may not attach to other magnetic cases. It will not attach to any other non-magnetic phones or cases.
- Supports simultaneous wireless charging output and USB-C input; wireless charging max output 15W, USB-C max input 20W, output 27W.
Safety Warnings
- Do not use or store in environments below 10°C (50°F) or above 40°C (104°F).
- Do not expose the device to an open flame or submerge it in water to avoid damaging the device.
- Always check for damage to the device, cables, or other accessories before using the device. If damaged, do not use the device.
- Do not disassemble or modify this product for any reason, as this may cause malfunctions, damage, and/or lead to the ingestion of disassembled parts by children.
- Do not expose the device to corrosive liquids, or high humidity as they will seriously damage the device and void the warranty.
- Do not use low quality or damaged cables and adapters, as it may cause damage.
- This product contains magnets. As such, it should be kept at a safe distance from medical devices such as pacemakers and defibrillators at all times so as to avoid interference. If no wireless charging is involved, a safe distance means at least 6 inches (15 cm); if wireless charging is involved, a safe distance means at least 12 inches (30 cm). If you suspect interference, discontinue use of the product immediately and consult a doctor and/or the manufacturer of the medical device.
FCC ID: 2APEW-2G524
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
IC: 24790-2G524
This device complies with Industry Canada licence-exempt RSS standard( s).
Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.”
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
This product complies with the radio interference requirements of the European
Community.
Declaration of Conformity
This product is intended for use within Europe. Electronic Silk Road Corp.
hereby declares that this product 2G524 is in compliance with the essential
requirements and other relevant provisions of Directive
2014/53/EU,2014/35/EU,2014/30/EUThe Declaration of Conformity for the 2G524 is
available from www.esrgear.com
This symbol indicates that this product shall not be treated as household
waste.Instead it shall be handed over to the applicable collection point for
the recycling of electrical and electronic equipment.
MODEL: 2G524
ESR Qi2 MagSlim Power Bank (10K)
Scan to watch a quick setup video
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>