ESR Tidal Metal-Frame Wireless Charger User Manual

June 5, 2024
ESR

ESR Tidal Metal-Frame Wireless Charger

ESR Tidal Metal-Frame Wireless
Charger PRO

FCC ID: 2APEW-ECW5-1

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o_and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator &your body.

IC: 24790-EWC5-1

This device complies with Industry Canada licence-exempt RSS standard( s) Operation is subject to the following two conditions:

  1. this device may not cause interference, and
  2. this device must accept any interference, including interference that may cause undesired operation of the device.”

Thank you for choosing ESR!

  1. The charging indicator willight up for 5 seconds when the charger is plugged in.
  2. After placing your phone on the charger, the indicator will flash slowly for 60 seconds.
  3. This charger is equipped with a magnetic ring. It will magnetically attach to phones compatible with this feature to ensure they stay perfectly aligned with the charger.
  4. Using the magnetic ring with a case on requires a case with a corresponding magnetic ring.
  5. Your phone will continue to charge even after the indicator turns off.
  6. The indicator will flash rapidly if an error is detected.

Important Reminders

  1. For maximum charging speed, use a Quick Charge 2.0/3.0 charging adapter.
  2. Remove all cards and metal attachments other than the magnetic ring from your case before placing it on the charger.
  3. If the charger overheats while charging, remove your phone and allow the charger to cool before resuming charging.
  4. This charger is not compatible with cases thicker than 5 mm.
  5. Please be sure to align your phone with the center of the charger.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals