ESR 3 in 1 15W Charging Station User Guide

October 27, 2023
ESR

ESR 3 in 1 15W Charging Station User Guide

PART LIST

INSTALLATION NOTES

  1. Place the phone support vertically downwards.

  2. Install the screw knob.

  3. Insert the watch charger into the base obliquely, then press it down.

  4. If you need to remove the watch charger, just press the red area at the bottom and then you could remove it.

  5. Align the phone charging port and insert.

  6. Also you could move phone support to reach a suitable distance.

  7. Put your watch on the watch charger.

  8. Put your AirPods on the AirPods holder.

WARM TIPS

  1. Keep in mind to charge your device before it runs out of power, otherwise it will shorten the working life of your devices.

  2. Reach us by your Amazon order detail page (select “order” “sold by” or “contact seller”) for warranty about it.

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly

approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals