HOFTRONIC SR-2833N-Z5 5 Zone Remote RF Dimmer Controller User Manual
- June 3, 2024
- HOFTRONIC
Table of Contents
HOFTRONIC SR-2833N-Z5 5 Zone Remote RF Dimmer Controller
IMPORTANT SAFETY DETAILS
- This device contains a button lithium battery that shall be stored and disposed of properly.
- DO NOT expose the device to moisture.
FUNCTION INTRODUCTION
Note: Before the first use, please remove the protective film on the
battery.
PRODUCT DATA
| OUTPUT | RF signal |
|---|---|
| OPERATION FREQUENCY | 869.5/916.5/434MHz |
| POWER SUPPLY | 3V(1xCR2032 battery) |
| OPERATING TEMPERATURE | 0-40°C |
| RELATIVE HUMIDITY | 8% to 80% |
| DIMENSIONS | 150×38.6x12mm |
- Control 5 zones of receivers separately
- Single color controller
- Compatible with all universal series RF receivers
- Waterproof grade: IP20
- The remote control is suitable for LED dimmers with article codes SR-1009SAC and SR-1009SAC-HP
PAIR WITH RF RECEIVER
Step 1: Do wiring the RF receiver according to the wiring diagram (please refer to the instruction of the RF receiver that you would like to pair with).
Step 2: Click the “Learning Key†button on the RF receiver or re-
power the receiver three times continuously to set it into pairing status
Step 3: Choose one zone and click I or O of the zone(e.g. zone 2), LED
lights connected with the RF receiver flicker once means the receiver is
paired with zone 2 successfully.
Note: one receiver can be paired with max 8 remote controls.
If you use multiple receivers, you have two choices:
Option 1: have all the receivers in the same zone, like zone 1
Option 2: have all the receivers in different zones, like zone 1, zone 2,
zone 3, zone 4, and zone 5. By using the different zone buttons, you can
easily control the different zones. You can also choose to switch on one or
more zones and switch off the others by the use of the main button.
INTENDED USE / APPLICATION
Product designed for the use in households and for other similar general
applications.
MOUNTING
Technical changes reserved. Read the manual before mounting. Mounting should
be performed by an appropriately qualified person. Any activities to be done
with disconnected power supply. Exercise particular caution. Product has a
protective contact/terminal. Failure to connect the protective lead may lead
to electric shock. Mounting diagram: see pictures. Check for proper mechanical
fastening and connection to electrical power prior to first use. The product
can be connected to a supply network which meets energy quality standards as
prescribed by law. To maintain the proper IP protection level, the right
diameter of the power cable should be selected for the cable gland used in the
product.
FUNCTIONAL CHARACTERISTICS
The product can only be used indoors
USAGE GUIDELINES / MAINTENANCE
Any maintenance work must be performed when the power supply is cut off and
the product has cooled down. Clean only with soft and dry cloths. Do not use
chemical detergents. Do not cover the product. Ensure free air access. Product
may heat up to a higher temperature. Product can only be supplied by rated
voltage or voltage within the range provided. It’s forbidden to use the
product with damaged protective cover. Product must not be used in
unfavourable conditions, e.g. dust, water, moisture, vibrations, explosive air
atmosphere, fumes, or chemical fumes, etc. Non-demountable product. Not
suitable for independent repairs.
ENVIRONMENTAL PROTECTION
Keep your environment clean. Segregation of post-packaging waste is
recommended. This labelling indicates the requirement to selectively collect
waste electronic and electrical equipment. Products labelled in this way must
not be disposed of in the same way as other waste under the threat of a fine.
These products may be harmful to the natural environment and health, and
require a special form of recycling/neutralising. Products labelled in this
way should be returned to a collection facility for waste electrical and
electronic goods. Information on collection centres is provided by local
authorities or sellers of such goods. Used items can also be returned to the
seller when new product is purchased, in quantity no larger than the purchased
item of the same type. The above rules regard the EU area. In the case of
other countries, regulations in force in a given country must be applied.
Contacting the distributor of our products in a given area is recommended.
DECLARATION OF CONFORMITY
DOCUMENTATION
This product has been manufactured and supplied in compliance with all
relevant regulations and directives applicable to all member states of the
European Union. The product complies with all applicable regulations and rules
in the country of sale. Formal documentation such as the declaration of
conformity, the safety data sheet, and the product test report is available
upon request.
CE DECLARATION
The product complies with the following directives:
- LVD: 2014/35/EU
- EMC: 2014/30/EU
- RoHS: 2011/65/EU
The complete Declaration of Conformity Document (DOC) is available upon request.
-
Imported by
-
HOF Trading B.V.
-
Fahrenheitstraat 11, 6003 DC Weert , The Netherlands Made in P.R.C.
Documents / Resources
|
HOFTRONIC SR-2833N-Z5 5 Zone Remote RF Dimmer
Controller
[pdf] User Manual
4406523, SR-2833N-Z5 5 Zone Remote RF Dimmer Controller, SR-2833N-Z5, 5 Zone
Remote RF Dimmer Controller, Remote RF Dimmer Controller, RF Dimmer
Controller, Dimmer Controller, Controller
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>