HOFTRONIC 2703820 Pir Motion Sensor Ceiling Light 360 Degree User Manual

Table of Contents

HOFTRONIC 2703820 Pir Motion Sensor Ceiling Light 360 Degree User Manual

Ensure the AC/main power is NOT connected and cannot be unexpectedly reconnected during installation.
This product must be installed by a qualified electrician in accordance with instructions provided and in compliance with recognised electrical and safety regulations relevant to the country where it is being installed.
This product must be installed to the latest edition of the Wiring Regulations published by Institution of Electrical Engineers, relevant to the regulations in your country.
This product may NOT be installed by minors or people with a mental disability.
This product is for indoor use only.
For your safety, please don’t open the case if you find it damaged after installation. Always ask the manufacturer, a service agent or a similar qualified person for help

Can identify day and night: The consumer can adjust working state in different ambient light. It can work in the daytime and at night when it is adjusted on the “sun” position (max). It can work in the ambient light less than 3LUX when it is adjusted on the “moon” position (min). As for the adjustment pattern, please refer to the testing pattern.
Time-Delay is added continually: When it receives the second induction signals within the first induction, it will restart to time from the moment.
Adjustable Time Delay: the length of time delay could be set according to the customers’ requirement, the minimum time of this item is 10sec±3sec, and the maximum is 3min±30sec.

Switch off the power.
Twist the plastic cover clockwise to take it off the sensor (img 1).
Pass the wire through the hole in the bottom. Then connect the power to the connection terminal of the sensor, according to the connectionwire diagram as shown on the picture. Install the sensor lamp in the desired position with screws (img 2).
WIRING DIAGRAM
After finishing installing, switch the power back on. Now you can test the sensor.

Height of installation : 2.2-4m

Detection Distance: Max.6m

Turn the TIME knob anti-clockwise on the minimum. Turn the LUX knob clockwise on the maximum (sun).
Switch on the power; the lamp will have no signal at the beginning. After Warm-up 30sec, the lamp can start work .If it receives the induction signal, the lamp will turn on. While there is no another induction signal any more, the lamp should stop working within 10sec±3sec.
Turn LUX knob anti-clockwise on the minimum (moon). If the ambient light is more than 3LUX, the lamp should not work. If the ambient light is less than 3LUX (darkness), the sensor would work. Under no induction signal condition, the lamp should stop working within 10sec±3sec.

Cannot be installed on the uneven and vibrating surface
There should be no hindrance and moving objects in front of the detection windows to affect detection
Avoid installing it near air temperature alteration zones such as air condition, central heating, etc
For your safety, please don’t open the case if you find hitch after installation

The load don’t work:
a. Please check if the connection-wiring of power and load is correct.
b. Please check if the load is good.
c. Please check if the working light sets correspond to ambient light.
The sensitivity is poor:
a. Please check if there has any hindrance in front of the detection window to affect to receive the signal.
b. Please check if the ambient temperature is too high.
c. Please check if the induction signal source is in the detection fields.
d. Please check if the installation height corresponds to the height showed in the instruction.
e. Please check if the moving orientation is correct.
The sensor cannot automatically close the charge:
a. Please check if there is continual signal in the detection field.
b. Please check if the time delay is the longest.
c. Please check if the power corresponds to the instruction.