HOFTRONIC 5423192 Fulco Solar Garden Spotlight User Manual

HOFTRONIC 5423192 Fulco Solar Garden Spotlight

IMPORTANT SAFETY DETAILS

• This product must be installed by a qualified electrician in accordance with the instructions provided and in compliance with recognized electrical and safety regulations relevant to the country it is being installed.
• Please handle carefully, and avoid rough handling and collision.
• This product may NOT be installed by minors or people with a mental disability.
• The product should NOT be covered with insulation material at any time. Unless using a model with an insulation guard.
• Please keep the surface of the solar panel clean, to make sure the product works at its best performance.
• It is important to install the light in a location that receives full sunlight each day, away from the shade caused by trees, buildings, etc. Shady locations will not allow the battery to be fully charged and will reduce the hours of nighttime light.
• The performance of solar light is dependent on geographical location, weather conditions, and seasonal sunlight availability. On cloudy days and during winter, the solar light will not receive as much direct sunlight, resulting in reduced brightness and reduced operating time.
• Dispose of the used battery properly! Do not dispose of the battery in the fire!

PRODUCT SPECIFICATIONS

• Solar panel: Polycrystalline 4V 2.5W, 18% efficiency
• Battery: LiFePo4 22650# 3.2V 2200mAh
• Light source: 38 LEDS
• Working time: 8-10 hours (after fully charged)
• Charging time: 4-6 hours under direct sunlight

Functions:

• Motion mode: The light shines very bright when motion is detected for 60 seconds and then goes to dim mode
• Security mode: The light shines very bright when motion is detected and then turns off
• Steady mode: The light stays on for 6-8 hours after the light has been fully charged
• IP Rating: IP65
• Material: ABS, PC
• Color: Black
• Switch type: on/off switch

INSTALLATION DETAILS

1. Turn the solar light on with the ON/OFF switch (fig. 1)
2. Pick a spot to install the solar light, where the solar light can receive an adequate amount of sunlight.
3. Use the supplied wall plugs and wall screws to mount the solar light on the desired surface (fig. 2). Adjust the light as desired. Adjust the solar panel so that it can receive the maximum amount of sunlight possible (fig. 3).

BATTERY REPLACEMENT

The performance of the battery may decrease over time (usually about 1-2 years), please replace the battery as shown on this picture.

1. Remove the 4 screws
2. Replace the battery

SWITCHING LIGHT MODES

• Mode 1: The motion sensor is activated by pressing the on/off button one time.
• Mode 2: Bright light is activated by pressing the button a second time.
• Mode 3: Dim light is activated by pressing the button a third time.

To turn the light off press the button a fourth time.

INTENDED USE/APPLICATION
Product designed for use in households and for other similar general applications.

MOUNTING

Technical changes reserved. Read the manual before mounting. Mounting should be performed by an appropriately qualified person. Any activities to be done with disconnected power supply. Exercise particular caution. The product has a protective contact/terminal. Failure to connect the protective lead may lead to electric shock. Mounting diagram: see pictures. Check for proper mechanical fastening and connection to electrical power prior to first use. The product can be connected to a supply network that meets energy quality standards as prescribed by law. To maintain the proper IP protection level, the right diameter of the power cable should be selected for the cable gland used in the product.

FUNCTIONAL CHARACTERISTICS
The product can only be used outdoors.

USAGE GUIDELINES/MAINTENANCE

Any maintenance work must be performed when the power supply is cut off and the product has cooled down. Clean only with soft and dry clothes. Do not use chemical detergents. Do not cover the product. Ensure free air access. The product may heat up to a higher temperature. The product can only be supplied by rated voltage or voltage within the range provided. It’s forbidden to use the product with a damaged protective cover. The product must not be used in unfavorable conditions, e.g. dust, water, moisture, vibrations, explosive air atmosphere, fumes, or chemical fumes, etc. Non-demountable product. Not suitable for independent repairs.

ENVIRONMENTAL PROTECTION

Keep your environment clean. Segregation of post-packaging waste is recommended. This labeling indicates the requirement to selectively collect waste electronic and electrical equipment. Products labelled in this way must not be disposed of in the same way as other waste under the threat of a fine. These products may be harmful to the natural environment and health and require a special form of recycling/neutralizing. Products labelled in this way should be returned to a collection facility for waste electrical and electronic goods. Information on collection centers is provided by local authorities or sellers of such goods. Used items can also be returned to the seller when a new product is purchased, in quantity no larger than the purchased item of the same type. The above rules regard the EU area. In the case of other countries, regulations in force in a given country must be applied. Contacting the distributor of our products in a given area is recommended.

COMMENTS/GUIDELINES
Failure to follow these instructions may result in e.g. fire, burns, electrical shock, physical injury, and other material and non-material damage. For more information about Hoftronic products visit www.hoftronic.com. Hoftronic shall not be responsible for any damage resulting from the failure to follow these instructions. Hoftronic reserves the right to make changes in the manual – the current version can be downloaded at www.hoftronic.com.

DECLARATION OF CONFORMITY

DOCUMENTATION
This product has been manufactured and supplied in compliance with all relevant regulations and directives applicable to all member states of the European Union. The product complies with all applicable regulations and rules in the country of sale.

Formal documentation such as the declaration of conformity, the safety data sheet, and the product test report is available upon request.

CE DECLARATION
The product complies with the following directives:

• LVD: 2014/35/EU
• EMC: 2014/30/EU
• RoHS: 2011/65/EU

The complete Declaration of Conformity Document (DOC) is available upon request.

Imported by

HOF Trading B.V.
Fahrenheitstraat 11, 6003 DC Weert , The Netherlands Made in P.R.C.
www.hoftronic.com.

References

• HOFTRONIC - HOFTRONIC

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>