JADEMAR LIGHTING JACL, JACLS Series Architectural Curve Lighting System Installation Guide
- July 16, 2024
- JADEMAR LIGHTING
Table of Contents
- JADEMAR LIGHTING JACL, JACLS Series Architectural Curve Lighting System
- Product Components
- Profiles interconnection
- Installation of profile
- Installation of lighting source (If field cut and made)
- Installation of diffuser
- Trimless recessed mount installation
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
JADEMAR LIGHTING JACL, JACLS Series Architectural Curve Lighting System
Product Components
Straight linear
Main components
-
Profile
-
End cap
-
Rigid module
-
Power supply
-
Diffuser
Connectors -
EX-26
Installation accessories -
Pendant cable
-
Surface mounted screws
-
Surface mounted accessories (lighting downward))
Curved linear
Main components
-
Profile
-
End cap
-
Rigid module
-
Power supply
-
Diffuser
Installation accessories -
Pendant cable
-
Surface mounted screws
-
Surface mounted accessories (lighting downward)
-
Surface mounted accessories (Lighting Inward/ Lighting Outward)
Connectors -
EX-26
Profiles interconnection
Installation of profile
Installation of lighting source (If field cut and made)
Interconnection of light source (If field cut and made)
Installation of diffuser
Surface mounted installation
- Install the 24VDC circuit in the ceiling or wall as needed for luminaire(s) location.
- Interconnect all the profile components for desired design and fasten the end cap to the profile with screws.
- Mount the light source into the profile per installation details above.
- Determine the drilling position of profile on the ceiling, and mark with a marking pen.
Trimless recessed mount installation
-
Using the actual profile section to be installed, trace the outside dimension of the profile onto the ceiling or wall where the luminaire will be installed. This will be the cut guide for the installation rough opening.
Make the continuous cut into ceiling or wall material to accommodate profile. -
Install the 24VDC circuit in the ceiling or wall as needed for luminaire(s) loaction.
-
Interconnect all the profile components for desired design and fasten the end cap to the profile with screws.
-
Mount the light source into the profile per installation details above.
-
Mount the Recessed Buckle Brackets (part RE-13) into the rough opening and secure with screws or other anchors as needed.
Install recessed buckle brackets at intervals sufficient to support each profile component section. -
Attach power to the luminaire and power on to test.
Mount the profile section(s) into the recess buckle brackets in the rough opening.
Install the diffuser per installation details above.
Finish the ceiling or wall surface to the edge of the profile. -
Finished
Quotations: quotes@jademar.com
To place an order: orders@jademar.com
Tel: (305) 640.0465 ǀ Fax: (305) 640.0468
WWW.JADEMAR.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>