JADEMAR LIGHTING JWP-R Rotating Wall Pack Light Instruction Manual

**JADEMAR LIGHTING JWP-R Rotating Wall Pack Light

**

INSTALLATION REQUIREMENTS

WARNING: Risk of electric shock and serious injury. SHUT OFF BREAKER AT PANEL BEFORE INSTALLING.

Warning:

1. Can not use the electric generator to test the LED lamp.

2. This luminaire must be installed in accordance with your local electrical codes and requirements;

3. Do not install the luminaire in the rain, to avoid lightning stroke and damage to luminaire.
   Installation Notice: 1. This luminaire must be installed by qualified electrician to avoid electric shock and fire accident;

4. Wear gloves before installation in order to avoid injury;

5. Turn off the power immediately when there is smoke and fire during installation; inform professionals to overhaul;

6. This luminaire is suited for outdoor use.

Standard wire:
L/live wire: N/null wire: Black\Brown; White\Blue;
Ground wire: Green\ Yellow-green

Warning: MIN 75 °C SUPPLY CONDUCTOR THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITHTHE AFPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OFTHE PRODUCT AND THE HAZARDS INVOLVED.

INSTALLATION STEPS – WIRING FROM THE BOTTOM OF THE LUMINAIRE

1. Cut the holes on the wall according to locating plate. Figure 1-1

2. Fix rubber plugs into holes Figure 1-2

3. Align mounting bracket with hole; tighten screws. Figure 1-3

4. Make wiring connection and go through isolation treatment Figure 1-4

5. Fix the luminaire on the bracket and tighten screws on the bottom. Figure 1-5

6. After Installation, tighten the screws. Figure 1-6

INSTALLATION STEPS – WIRING FROM THE SIDE OF LUMINAIRE

1. Cut the holes on the wall according to locating plate. Figure 2-1

2. Fix rubber plugs into holes Figure 2-2

3. Align mounting bracket with hole; tighten screws. Figure 2-3

4. Fix the luminaire on the bracket; make wiring connection from side and go through isolation treatment. Figure 2-4

5. Tighten the pipe on the luminaire; after installation, tighten the screws. Figure 2-5

INSTALLATION STEPS – BRACKET INSTALLATION

1. Cut holes on the wall according to locating plate. Figure 3-1

2. Fix rubber plugs into holes. Figure 3-2

3. Align mounting bracket with hole; tighten screws. Figure 3-3

4. Pass wires through rubber ring and junction box, align with holes and lock junction box. Figure 3-4

5. Make wiring connection and go through isolation treatment Figure 3-5

6. Push the wires into junction box; after installation, tighten the screws. Figure 3-6

CUSTOMER SERVICE

Miami, FL USA – info@jademar.com
T: 305.640.0465 – F: 305.640.0468
WWW.JADEMAR.COM

Revised 04/2023

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>