rutec 7493FF VARDAflex AC Eco Installation Guide
- July 8, 2024
- rutec
Table of Contents
rutec 7493FF VARDAflex AC Eco
IMPORTANT SAFETY- / INSTALLATION INSTRUCTIONS:
Electric shock hazard
- Commission a qualified electrician with the installation. All liability claims are void for lights that have not been installed in accordance with the European safety guidelines.
- Switch off the power before installation. Ensure that the power cannot be accidentally switched on again.
- Check that the connections are correct and check for short circuits before switching the power back on.
- The LED strip light may only be switched on if the strip light has been properly closed.
Attention:
- The LED strip must be cut exactly at the specified dividing lines, otherwise the dividing unit will be destroyed.
FOR THE INSTALLATION LOCATION AND THE PRODUCT MUST BE TAKEN INTO CONSIDERATION:
The product is only suitable for installation indoors and outdoor areas. The permissible ambient temperature for the product is -20 to +40° C.
Improper use will destroy the product and product and we will not accept any warranty. Therefore, please observe our installation instructions
TECHNICAL DRAWING
DISPOSAL:
Dispose of electrical and electronic devices in an environmentally friendly manner. Further information can be obtained from your local authority
TECHNICAL DATA:
Power supply:
230V AC, 50Hz
Power/m:
4,5W per meter; 450W per reel
Current strength/m:
0,039A per meter; 1,956A per reel
Radiation angle:
120°
Quantity LED:
56 LEDs per meter; 2800 LEDs per reel
Length:
maximum 50 metres per connection
Dimensions:
50.000 x 17 x 13,5 mm
Bending diameter:
150 mm
Lifetime:
L70 B50: >35.000 h
CERTIFICATES AND SYMBOLS
CE-compliant with the applicable European directives.
RoHS mark of conformity for products that do not contain heavy metals (2011/65/EU)
REACH mark of conformity for products whose chemical components are known, registered and authorised (1907/2006/ EC).
Parallel connection: Suitable for through-wiring.
Protection class II (double or
reinforced insulated housing)
Protected against strong water jets.
UV-resistant
INSTALLATION
Electric shock hazard
Before installation, switch off the power supply and secure it against being switched on again.
SHORTEN LED-STRIP
Electric shock hazard
Switch off the voltage before installation. VARDAflex AC Eco LED-Strip can be disconnected after each 14LEDs (250mm).
Attention :
Only cut the VARDAflex AC Eco LED strip at the marked points. A cutter is required if the VARDAflex AC Eco LED strip is tightly fitted! After shortening the pcb, the cut-off point must be properly closed again with an appropriate mounting accessory in order to maintain protection class SKII.
BENDING DIRECTION
Attention:
When processing VARDAflex AC Eco, it is important to comply with the prescribed bending radi i and bending directions. Improper handling will lead to the destruction of the product and we accept no liability whatsoever.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>