rutec 87640 LED Power Supply 48V 75W IP67 Instruction Manual

: June 21, 2024
: rutec

Table of Contents

LED power supply 48V, 75W IP67
- 87640
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LED power supply 48V, 75W IP67

87640

MOUNTING AND OPERATING INSTRUCTIONS

IMPORTANT SAFETY-/ INSTALLATION INSTRUCTIONS:

General notes for installation

Commission a qualified electrician to carry out the installation.
Always ensure that the unit is installed in a location with good ventilation to ensure the correct operating temperature.
Never connect the cables when the unit is switched on.
Check the correctness of the connections and check for short circuits before switching on the voltage.
Please do not carry out any repairs yourself. This will invalidate the manufacturer`s warranty.

FOR THE INSTALLATION SITE AND THE PRODUCT MUST BE TAKE INTO ACCOUNT:

The product is only suitable for indoor and outdoor use. The permissible ambient temperature for the product is -40 to +50° C.

Improper use will destroy the product and we will not accept any guarantee. Therefore, please observe our assembly instructions.

POWER SUPPLY UNITS PER CIRCUIT BREAKER:

LS	B10	B16	B25	C10	C16	C25
Stk.	5	8	12	9	14	22

TECHNICAL DATA:

Input:	220-277V AC, 50/60Hz, 186-250V DC
Output:	48V DC, 76.8W max.
Ambient temperature	-40 bis +50°C
Psb:	0.00 W
Pno:	1.6 W
Efficiency at full load:	87.5 %
Tolerance:	±3 %

TECHNICAL PRODUCT DIMENSIONS:

Dimensions (L x W x H): 158 x 68 x 33,5 mm

a: BROWN(ACL)
b: BLUE(ACN)
c: YELLOW&GREEN (GND)
d: AC INPUT(VDE H05RN-F 3×1.0mm²)
e: DC OUTPUT(UL SJTW 2×18AWG)
f: RED(V+) BLACK(V-)

MARKS AND SYMBOLS:

CE-compliant with the applicable European directives

RoHS mark for products that do not contain heavy metals (EC Directive 2002/95/EC)

REACH test mark for products whose chemical components are known, registered and authorised (1907/2006/EG)

Parallel connection Suitable for through-wiring.

Independent operating device

Safety transformer, short-circuit proof

SELV Safety extra-low voltage

Protection class I (protective conductor connection)
Protected against temporary submersion

DISPOSAL:

Dispose of electrical and electronic equipment in an environmentally sound manner. For more information, contact your local authority.

DESCRIPTION:

GENERAL INFORMATION:

The LED power supply unit 87640 is a non-dimmable power supply on the primary side, which outputs a rectified constant voltage of 48V DC on the secondary side for a maximum power consumption of 76.8W.

WIRING DIAGRAM:

a: 230V AC, 50Hz
b: LED-Power supply (12 | 24 | 48 V DC)

INSTALLATION:

First connect the LED strip to the secondary side of the power supply unit. Pay attention to the correct polarity + (anode) and – (cathode).
Connect the primary side of the LED power supply unit to the 230 V AC mains voltage in a de-energised state, observing the five safety rules.
Check that the input and output cables have been connected correctly before switching on the power to operate the LED power supply.

INSTALLATION NOTE:

We recommend a flexible cable and a maximum connection length of 4.0 m for the secondary connection. With a longer connection cable, design the cross- section of your cable so that the expected voltage drop is 0.2V DC to prevent a brightness or colour shift in the LED strip.