GETINGE XEN Enzymatic+ pH Neutral Quadruple Enzyme Liquid Detergent User Guide
- June 16, 2024
- GETInGE
Table of Contents
GETINGE XEN Enzymatic+ pH Neutral Quadruple Enzyme Liquid Detergent
Instructions for Use
XEN Enzymatic+ is a pH-neutral, quadruple-enzyme liquid detergent for use in automated washer applications, including washer-disinfectors and cart washers, as well as ultrasonic cleaners. Enzymatic+ is low foaming to optimize performance of the automated washer. Its four enzymes—protease, lipase, amylase, and cellulase—break down blood and proteins, fats and oils (lipids), carbohydrates, and polysaccharides, respectively.
Order no. Description
6036002901 Enzymatic+ 1 x 5 L.
6036003001 Enzymatic+ 1 x 5 gal.
6036003101 Enzymatic+ 1 x 15 gal.
Directions for Use in Automated Washing Equipment
The detergent should be automatically dosed into the wash cycle. Dosing is
0.03–0.26 oz./gal. (0.2–2.0 ml/l), depending on soil load and water quality.
Higher doses will be required for higher soil loads and for poor water
quality. Automated washers should be set to dose at 95°F (35°C). The wash
temperature should be set at 122°F–140°F (50°C–60°C).
Directions for Use in Manual Washing
-
Fill the sink or basin to an appropriate level with warm water (at a temperature of 77°F–113°F/25°C–45°C), ensuring the quantity of water used allows the correct dose to be calculated. Dosing is 0.26–0.51 oz./gal.
(2.0–4.0 ml/l), depending on soil load and water quality. Higher doses will be required for higher soil loads and for poor water quality. -
Soak the items for a minimum of 2 minutes, ensuring sufficient time to obtain the desired cleaning. Cleaning times may be longer with a heavier soil load.
-
Rinse all items thoroughly after cleaning, ensuring any lumens are also flushed thoroughly.
-
Dispose of sink solution when it is visibly soiled or cool to the touch. Per AAMI guidelines, it is best practice to dispose of solution and refill sink between each use, and/or when the sink solution temperature falls below 77°F–113°F (the temperature range stated on the IFU).
Instructions for Ultrasonic
-
Fill the ultrasonic bath to an appropriate level with warm water (at a temperature of 77°F–113°F/25°C–45°C), ensuring the quantity of water used allows the correct dose to be calculated. Dosing is 0.26–0.51 oz./gal.
(2.0–4.0 ml/l), depending on soil load and water quality. Higher doses will be required for higher soil loads and for poor water quality. -
Run the ultrasonic cleaning cycle, ensuring sufficient time to obtain the desired cleaning. Cleaning times may be longer with a heavier soil load.
-
Rinse all items thoroughly after cleaning, ensuring any lumens are also flushed thoroughly.
-
Discard the solution in accordance with facility policy. Solutions should not be reused if they are visibly soiled.
Caution
- Do not mix with other chemicals.
- Wear correct PPE and follow applicable guidelines. Additional information on SDS.
- Check material compatibility before use.
Danger: May cause allergy or asthma symptoms or breathing difficulties if
inhaled. Avoid breathing fumes, mists, vapors, or spray. In case of inadequate
ventilation, wear respiratory protection.
First Aid: IF INHALED: If breathing is difficult, remove person to fresh air
and keep at rest in a comfortable position for breathing. If experiencing
respiratory symptoms, call a poison center or doctor.
Dispose of contents and container in accordance with local, regional,
national, and international regulations.
Contains triethanolamine, protease enzyme, 1,2-benzisothiazol-3(2H)-one,
amylase, lipase, and cellulase enzymes, and a colorant. For more ingredient
information, visit www.getinge.com
Storage Information
Store in a cool, dry place protected from frost and away from acids and strong oxidizing agents. Store upright in original containers. Optimum storage temperature 41°F–77°F/5°C–25°C.
| Aluminum| Anodized Aluminum| Titanium| Copper| Brass| Gold| Nickel| Cobalt
Chrome| Matte chrome plated| Stainless steel| Glass| Ceramics| Rubber|
Plastic| Teflon™/ PTFE| Polycarbonate
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---
Enzymatic+| •| •| •| •| •| •| •| •| •| •| •| •| •| •| •| •
• = The product is suitable for the material
○ = Pay special attention to the guidelines from the instruments/device
manufacturer
Teflon™ is a trademark of Chemours.
Getinge is a registered trademark of Getinge AB or its subsidiaries or
affiliates in the United States or other countries.
Copyright 2024 Getinge AB or its subsidiaries or affiliates. • All rights
reserved.
Manufacturer: Quadralene Ltd, Unit 3, St. Modwen Park, Andressey Way, Derby,
DE21 6YH, United Kingdom.
Sales Office, US: 1 Geoffrey Way, Wayne, NJ 07470, USA
Sales Office, Canada: 90 Matheson Blvd West, Suite 300, Mississauga, Ontario
L5R 3R3, Canada
www.getinge.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>