EPROPULSION Q2 Outboard Motor User Guide
- June 16, 2024
- EPROPULSION
Table of Contents
PROPULSION Q2 Outboard Motor
Elite Quick Start
Before first use, please ensure that you have read the user manual and thoroughly understand the potential risks related to the operation of the equipment. Before first use, please fully charge the outboard motor.
Warning
- Please always wear a life jacket before boating, and tie the kill switch lanyard to your wrist or life jacket.
- Before each trip, always check the status of the outboard motor and the battery level.
- After use, please remove the kill switch, and press and hold the power button for 2 seconds to turn off the motor.
- All parts of the outboard that have been underwater, or splashed, should be rinsed with fresh water after each use.
Mount the Clamp Bracket
Before mounting, please check the clamp bracket. Place the clamp bracket in
the centre of the transom and rotate the tightening handle to lock.
Tiller Angle
Free Mode
Rotate the tiller adjustment toggle 90° in either direction. The toggle will
spring outwards as it’s rotated and the tiller can then be adjusted freely to
any angle from -90° to 90°.
Fixed Mode
Pull out the tiller adjustment toggle, and the tiller can be adjusted to any
of four fixed positions: -90°, 0°, 45°, and 90°. Push the toggle back in to
lock it.
Installation and Removal
Motor Installation
Step 1: Pull out or rotate the tiller adjustment toggle to unfold the
tiller.
Step 2: Hold the outboard motor with both hands and align the quick- release mount with the clamp bracket damping shaft, then slowly lower the motor into place.
Motor Removal
Step1: Press the quick-release button to release.
Step 2: Hold the outboard motor with both hands and slowly lift it
upwards.
Operation
Start the Outboard Motor
Step 1: Attach the kill switch wristband to your wrist or life jacket.
Step 3: Press and hold the power button for 2 seconds to turn on the
outboard motor.
Step 2: Insert the kill switch into the kill switch hole.
Step 4: Turn the throttle handle to move forward or backward.
Trim and Tilt Angle
Trim Angle
Step 1: Push the trim pin inward and rotate it 180°, with the handle
facing upward. Pull out the trim pin.
Step 2: Adjust the trim angle of the outboard motor as desired and insert
the trim pin into the corresponding limit hole.
Step 3: Push the trim pin inward and tighten it, then rotate it 180°.
Motor Tilt
Step 1: Lift the trim lever upwards.
Step 2: Tilt the outboard motor to the highest point it will go, and release it. The shaft will rest in place at 75 to the transom.
Display
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>