EPROPULSION Navy Series Electric Outboard Motor Instruction Manual
- June 12, 2024
- EPROPULSION
Table of Contents
EPROPULSION Navy Series Electric Outboard Motor
Pairing to the Outboard with a NAVY Battery by Wire
- Step1: First connect the main switch cables to the NAVY Battery.
- Step2: Connect the main switch cables with the power cables from the outboard.
- Step3: Connect NAVY outboard motor to the NAVY Battery with the communication cable.
- Step4: Connect the NAVY Control System to the NAVY Battery with the communication cable.
Safety Notes
Do not short-circuit the main switch with other power supplies. The main
switch should be mounted on the boat, and the back plate of the main switch
should not be removed.
If “ ” shows on start-up, it indicates system initialization.
After pairing Remote Control/Tiller Handle to the Outboard, it can switch
between wireless and wired communication automatically.
If the Control System or the outboard is replaced with a new one, the original
wireless link will break and wireless communication failure will occur. The
main page of the LCD panel on the Remote Control/Tiller
Handle will display as below. In this case, users should conduct pairing
again.
However, if the Remote Control/Tiller Handle and the outboard motor are not replaced, but the LCD panel still displays like this, you should check and:
- Make sure the Remote Control is not far from the outboard motor;
- Make sure all the equipment involved is normally powered on.
If the Remote Control/Tiller Handle still displays like Figure 5-17 after check, it indicates an error has occurred. Please contact your dealer for repair.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>