rutec 87620 24V LED Power Supply Instruction Manual

Rutec 87620 24V LED Power Supply Instruction Manual

LED power supply 24V, 75W IP67
87620
MOUNTING AND OPERATING INSTRUCTIONS

IMPORTANT SAFETY-/ INSTALLATION INSTRUCTIONS:

Allgemeine Hinweise zur Inbetriebnahme
General notes for installation

• Commission a qualified electrician to carry out the installation.
• Always ensure that the unit is installed in a location with good ventilation to ensure the correct operating tempe-rature.
• Never connect the cables when the unit is switched on.
• Check the correctness of the connections and check for short circuits before switching on the voltage.
• Please do not carry out any repairs yourself. This will in-validate the manufacturer‘s warranty.

FOR THE INSTALLATION SITE AND THE PRODUCT MUST BE TAKE INTO ACCOUNT:

The product is only suitable for indoor and outdoor use. The permissible ambient temperature for the product is -40 to +50° C.

Improper use will destroy the product and we will not ac- cept any guarantee. Therefore, please observe our assem- bly instructions.

POWER SUPPLY UNITS PER CIRCUIT BREAKER:

TECHNICAL DATA:

TECHNICAL PRODUCT DIMENSIONS:

Dimensions (L x W x H): 158 x 68 x 33,5 mm

MARKS AND SYMBOLS:

CE-compliant with the applicable European directives

RoHS mark for products that do not con- tain heavy metals (EC Directive 2002/95/EC)

REACH test mark for products whose che- mical components are known, registered and authorised (1907/2006/EG)

Parallel connection
Suitable for through-wiring.

Independent operating device

Safety transformer, short-circuit proof

Safety extra-low voltage

Protection class I (protective conductor connection)

Protected against temporary submersion

DISPOSAL:

Dispose of electrical and electronic equipment in an environmentally sound manner. For more information, contact your local authority.

DESCRIPTION:

GENERAL INFORMATION:

The LED power supply unit 87620 is a non-dimmable power supply on the primary side, which outputs a rectified constant vol- tage of 24V DC on the secondary side for a maximum power consumption of 74.4W.

WIRING DIAGRAM:

INSTALLATION:

• First connect the LED strip to the secondary side of the power supply unit. Pay attention to the correct polarity + (anode) and – (cathode).
• Connect the primary side of the LED power supply unit to the 230 V AC mains voltage in a de-energised state, observing the five safety rules.
• Check that the input and output cables have been connected correctly before switching on the power to operate the LED power supply.

INSTALLATION NOTE:
We recommend a flexible cable and a maximum connection length of 4.0 m for the secondary connection. With a longer connection cable, design the cross- section of your cable so that the expected voltage drop is ≤0.2V DC to prevent a brightness or colour shift in the LED strip.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>