Align Toilet Paper Holder User Manual
- June 8, 2024
- Moen
Table of Contents
Align is a trademark of Moen® Incorporated ©2019 25300 Al Moen Drive • North
Olmsted, OH 44070-8022
Customer Service USA: 1-800-882-0116
International Customer Service:
1-440-962-2217
www.moen.com
Don’t forget to register and review your product by visiting moen.com/product- registration.
Installation Instructions for Towel Ring, 18 in. and 24 in. Towel Bars, and Pivoting Paper Holder
Tools Required: Phillips screwdriver, drill, 1/4” drill bit, hammer,
level, tape
Hardware Kit Contents: 4 anchors, 1 hex wrench
Note: Directions below are for installation into drywall. If installing
product into a stud, use the wood screws only.
- Position the mounting template on the wall in the desired location.
- Using a level, align the template and tape it to the wall.
- Drill two 1/4” holes at each mounting post location that corresponds to your product. (We recommend using the horizontal holes for drywall installation).
- Remove the template from the wall.
- Lightly tap anchors until flush with the wall.
- Remove mounting posts from the product assemblies by loosening each setscrew.
- One at a time, place each mounting post over anchors (notch facing downward) and insert screws through post into anchors.
- Tighten screws.
Towel Bars
9) Assemble the towel bar and posts.
10) While assembled, position each end post with setscrews facing down and
place over both mounting posts. Tighten the setscrew at the bottom of each
post.
Pivoting Paper Holder
9) Place each assembly over the mounting posts with setscrews facing down.
Pivoting post with bar should be on the left side. Tighten both setscrews.
Align Toilet Paper Holder User Manual – Optimized PDF
Align Toilet Paper Holder User Manual – Original PDF
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>