MOEN YB0186BN Adler Brushed Nickel Wall Mount Towel Ring Instruction Manual

MOEN YB0186BN Adler Brushed Nickel Wall Mount Towel Ring

Specifications

• Brand: AdlerTM
• Customer Service USA: 1-800-882-0116
• International Customer Service: 1-440-962-2263
• Website: www.moen.com
• Model Number: INS10677A
• Collection: Installation Instructions for 18 in. and 24 in.
  Towel Bars, Pivoting Paper Holder, Robe Hook, and Towel Ring

Product Usage Instructions

Tools Required

1. Phillips screwdriver
2. Drill
3. 5/16 drill bit
4. Hammer
5. Level
6. Tape measure

Installation Instructions

Note
The directions below are for installation into drywall. If installing the product into a stud, use the wood screws only.

Hardware Kit Contents

• 4 plastic toggle anchors
• 4 wood/anchor screws
• 1 plastic pin
• 1 hex wrench
• 2 anchors for single mounting

Collection
Installation Instructions for 18 in. and 24 in. Towel Bars, Pivoting Paper Holder, Robe Hook and

Towel Ring
Tools Required: Phillips screwdriver, drill, 5/16″ drill bit, hammer, level, tape
Note: The directions below are for installation into drywall. If installing the product into a stud, use the wood screws only.
Hardware Kit Contents: 4 plastic toggle anchors, 4 wood/anchor screws, 1 plastic pin, 1 hex wrench, 2
anchors for single-mounting

1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16″ holes at each mounting plate location that corresponds to your product.
4. Remove the template from the wall.
5. Fold the ends of the plastic toggle anchor together (see Figure 1) and insert it into each hole in the wall.
6. Lightly tap anchors until flush with the wall.
7. One at a time, insert a plastic pin into each anchor and lightly tap to activate the anchor (see Figure 2).
8. Remove the pin and repeat on all anchors.
9. Remove mounting plates from the posts by loosening each set screw.
10. Place the mounting plate on the wall over the installed wall anchors with “UP” facing you.
11. Insert screws through the mounting plate into the anchors. Tighten the screws.
12. Place posts over the mounting plates with the setscrew facing down and tighten the setscrew

For Single Bracket Mounting Instructions:

1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16″ holes at the mounting post location that corresponds to your product.
4. Remove the template from the wall.
5. Lightly tap the anchor until flush with the wall.
6. One at a time, insert a plastic pin into the anchor and lightly tap to activate the anchor.
7. Remove mounting plates from the posts by loosening each set screw.
8. Place the mounting plate on the wall over the installed wall anchors with “UP” facing you.
9. Insert screws through the mounting plate into the anchors. Tighten the screws.

Position bracket and drill holes as indicated

Level Line

Moen Incorporated
25300 Al Moen Drive North Olmsted, OH 44070-8022
Customer Service USA: 1-800-882-0116
International Customer Service: 1-440-962-2263
Adler is a trademark of Moen Incorporated
www.moen.com

References

• Register Your Product | Moen

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>