Satellite 18036 Ceiling Fan Remote Controller User Manual
- June 3, 2024
- SATELLITE
Table of Contents
Satellite 18036 Ceiling Fan Remote Controller
LEARNING PROCESS
NOTE: The Hand Held Remote Control is equipped with a learning ID function which has code combinations to prevent potential interference from other remote units.
Step: 1
Install the batteries AAA 1.5V*2 PCS in the transmitter. Within 30 seconds of
turning the Receiver AC power ON, press the transmitter LEARN button
Step: 2
Hold LEARN button for about 3 seconds, once the receiver has detected the ID,
the light of the ceiling fan will be blinking twice and the fan turn on at low
speed. This will indicate the receiver has learned the ID that was previously
selected on the transmitter.( The 0/1 switch on the back of the transmitter is
in the “0” state, and it can be directly controlled without pairing. The 0/1
switch is in the “1” state, need to proceed to learn.)
Note: After the AC power is on, do not press any other buttons on the
transmitter before learning ok. Because doing so will cause the procedure to
fail. After completing the steps above, you should be able to operate the
ceiling fan and light. If the ceiling fan is not responding to the
transmitter, please turn the power off to the receiver and repeat steps 1 and
2.
Remove the batteries if not used for long periods of time to prevent damage to the handheld remote. The batteries must be removed from the transmitter before it is scrapped and the batteries shall be disposed of safely.
FUNCTIONS OF TRANSMITTER
- Turn on/off the ceiling fan and light
- Turn on/off the ceiling fan
- FAN SPEED
- Press the button to increase speed and the LED bar will show at the same time. All LED is brightened for the highest speed. Press speed.
- Turn on/off the light
- LIGHT DIMMER Press and hold to dim or brighten lights to the desired level and release.
- COLOR TEMP. Press the button to switch the color.
- Press this button to switch the color temperature when the light is on.
To assure continued FCC compliance
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. –Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION
To assure continued FCC compliance:
Any changes or modifications not expressly approved by the grantee of this
device could void the user’s authority to operate the equipment.
FCC ID：2AQZU-18036
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.+
RF exposure statement
This equipment complies with the FCC and ISED radiation exposure limits set
forth for an uncontrolled environment. This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter.
IC WARNING
This device contains license-exempt transmitter(s) that comply with
Innovation, Science, and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>