VASETA A8 Portable Blender Instruction Manual
- June 15, 2024
- VASETA
Table of Contents
VASETA A8 Portable Blender
Product Information
Specifications
- Model: A9
- Jar Capacity: 600ml
- Jar Material: AS (Food Grade)
- Base Material: ABS
- Blade Material: 304 Stainless Steel
- Blending Voltage: 7.4V
- Charging Voltage / Current: 5V / 1A
- Battery Type / Capacity: 18650 / 2000mAh*2
- Motor Speed: 18000rpm
- Charging Time: About 3 to 5 hours
- Single blend time of Blend mode: 30-second cycle
- Maximum blend time of Pulse mode: 30 seconds
Cautions
- Food Contact Compliance
- Keep Away From Fire
- Nonmicrowaveable
- Fragile
Product Usage Instructions
Your First Blend
Make sure your blender is fully charged by checking whether all indicator
lights are green before your first blend. Tighten the body and base until the
magnet is aligned with the power button.
Remember to clean it immediately after use.
Procedure
- Cut fruits into small pieces before adding to the blender to fill up about 60% of the jar capacity.
- Add some drinkable liquid until it reaches 80% of the jar capacity.
- Tighten the lid and tilt down the blender to make sure fruit pieces are not stuck under the blades.
- Blend Mode: Click once power button to start blending and green lights on. Slightly tilt it back and forth while blending if desired.
- Pulse Mode: Double-click power button to enter into pulse mode and yellow lights on. Press and hold the power button repeatedly to pulse. Pulse mode will automatically end after 5 seconds of inactivity and yellow lights off.
Troubleshooting
Malfunction Analysis
- All indicator lights in red or no light, unable to start.
- All indicator lights flicker in red and green alternately, unable to start.
- Stop working after 5 seconds.
- Stop working, all indicator lights flicker in red for 8 seconds.
Troubleshooting
- Ran out of battery. Charge it for 3 to 5 hours to make sure that it gets a full charge.
- The jar is not tightened to the base. Tighten the jar and base, make sure the magnet is aligned with the power button.
- Leakage. Blender is empty. Add ingredients into blender to start blending.
- Ingredient is too thick or volume too big, motor overload protection. Add some liquid or cut ingredients into smaller pieces or shift into Pulse Mode, then restart it.
- The seal is not placed properly; jar/cap is cross-threaded.
- Check seals; check thread alignment when screwing on jar/cap.
Pro Tips:
- BLEND MODE: Perfect for smoothies, shakes, and mixed drinks.
- PULSE MODE: Perfect for salsa, jams, small ice-cube, frozen fruits, and extra tough ingredients.
Check Battery Level
- 1% – 17%: No lights
- 18% – 33%: 2 green lights on
- 34% – 50%: 4 green lights on
- 51% – 67%: 6 green lights on
- 68% – 83%: 8 green lights on
- 84% – 99%: 10 green lights on
- Fully charged: All green lights on, red light off
Cleaning Instructions
The USB port is waterproof. It is prohibited to soak the stand in water or put it into the dishwasher for cleaning for a long time to avoid damage to the battery or motherboard after water ingress.
Recommended Usage
Do not mix with hard-shelled fruits, nuts, and large pieces of frozen fruits. It is recommended that fruits or vegetables be cut into small pieces of 1 inch/CM to avoid jamming of the blade and blocking protection.
FAQ (Frequently Asked Questions)
Q: How long does it take to fully charge the blender?
- A: It takes about 3 to 5 hours to fully charge the blender.
Q: What is the maximum blend time in Pulse mode?
- A: The maximum blend time in Pulse mode is 30 seconds.
Q: Can I put the blender in the dishwasher for cleaning?
- A: It is prohibited to put the blender into the dishwasher for cleaning for a long time to avoid damage to the battery or motherboard after water ingress.
Procedure
Step 1
- Cut fruits into small pieces before adding into the blender to fill up about 60% of the jar capacity.
Step 2
- Add some drinkable liquid until it reaches 80% of the jar capacity.
Step 3
- Tighten the lid and tilt down the blender to make sure fruit pieces are not stuck under the blades.
Step 4
- Blend Mode: Click once power button to start blending and green lights on. Slightly tilt it back and forth while blending if desired.
- Pulse Mode: Double-click the power button to enter pulse mode and yellow lights on.
- Press and hold the power button repeatedly to pulse. Pulse mode will automatically end after 5S of inactivity and the yellow lights off.
Tips
Pulse Mode
- Double-click to switch pulse mode, orange light will be on.
- Bottom cover
- The USB port is waterproof. It is prohibited to soak the stand in water or put it into the dishwasher for cleaning for a long time to avoid damage to the battery or motherboard after water ingress.
- Do not mix with hard-shelled fruits, nuts, and large pieces of frozen fruits. It is recommended that fruits or vegetables be cut into small pieces of 1 inch/CM to avoid jamming the blade and blocking protection.
Specification
- Model: A9
- Jar Capacity: 600ml
- Jar Material: AS
- Base Material: ABS
- Blade Material: 304 Stainless Steel
- Blending Voltage : 7.4V Charging Voltage / Current : 5V / 1A
- Battery Type / Capacity: 18650 / 2000mAh*2
- Motor Speed: 18000rpm
- Charging Time: About 3 to 5 hours
- Single blend time of Blend mode: a 30-second cycle Maximum blend time of
- Pulse mode: 30 seconds
Malfunction Analysis and Troubleshooting
Malfunction | Analysis | Troubleshooting |
---|---|---|
All indicator lights in red or no light, unable to start. | Ran out of | |
battery. | Charge it for 3 to 5 hours to make sure that it gets a full charge. | |
All indicator lights flicker in red and green alternately, unable to start. | ||
The jar is not tightened to the base. | Tighten the jar and base, and make sure |
the magnet is aligned with the power button.
Stop working after 5 seconds.| The blender is empty.| Add ingredients into the
blender to start blending.
Stop working, all indicator lights flicker in red for 8 seconds.| If the
ingredient is too thick or the volume too big, motor overload protection.| Add
some liquid or cut ingredients into smaller pieces or shift into Pulse Mode,
then restart it.
Leakage.| The seal is not placed properly; the jar/cap is cross-threaded.|
Check seals; check thread alignment when screwing on jar/cap.
NOTE
- The product is suitable for USB Type-C cable. Suitable for power bank charging as well.
- When not used for a long time, charge it fully first to keep the battery in a high voltage state to prevent damage.
Cautions
- DO NOT remove the lid or add something rigid to your blender when it is blending.
- DO NOT submerge the base into water to prevent base elements from damaging and make sure it is off before cleaning.
- DO NOT disinfect your blender in microwave or hot water above 80°C.
- DO NOT put your blender in the freezer.
- DO NOT clean your blender with any kind of metallic spiral ball to prevent parts from scratching or damaging.
- DO NOT clean your blender with a dishwasher machine.
- DO NOT charge your blender when it is wet.
- DO NOT repair or disassemble it by yourself otherwise your warranty will be void. If a malfunction occurs, kindly contact us.
Your First Blend
- Make sure your blender is fully charged by checking whether all indicator lights are green before your first blend. Tighten the body and base until the magnet is aligned with the power button.
- Remember to clean it immediately after use.
Pro Tips
- BLEND MODE: Perfect for smoothies, shakes, and mixed drinks.
- PULSE MODE: Perfect for sala, jams, small ice-cube, frozen fruits, and extra tough ingredients.
Check Battery Level
- 1%- 17%: no lights
- 18%-33% : 2 green lights on
- 34%-50% : 4 green lights on
- 51%-67% : 6 green lights on
- 68%-83% : 8 green lights on
- 84%-99% : 10 green lights on
- Fully charged, all green lights on, red light off
PORTABLE BLENDER
- Imported Environmental-friendly Materials CE, ROHS, FCC Approval
Warranty
- We offer 12 months warranty on all our products for fault or product quality.Accidental damage or damage as a result of misuse is not covered under this warranty.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>