Satellite Electronic 18028 DC Power Ceiling Fan Remote Control User Manual
- June 6, 2024
- Satellite Electronic
Table of Contents
Satellite Electronic 18028 DC Power Ceiling Fan Remote Control
DC POWER CEILING FAN REMOTE CONTROL MANUAL
LEARNING PROCESS
NOTE: The Hand Held Remote Control System is equipped with a learning
frequency function which has code combinations to prevent potential
interference from other remote units.
Step: 1. Install the DC1.5V/AAA 2pcs batteries. Within 30 seconds of
turning the receivers AC power ON. Press the transmitter’s “LEARN” button.
Step: 2. Hold the “LEARN” button for over 5 seconds, once the receiver
has detected the frequency, the receiver will make sound, Bi Bi, twice. This
will indicate the receiver has learned the frequency that was previously
selected on the transmitter. 
NOTE: After the AC power is on, do not press any other button on the
transmitter before pressing the “LEARN” button, Because doing so will cause
the procedure to fail.
After completing the steps above, you should be able to operate the ceiling
fan and light. If the fan is not responding to the transmitter, please turn
the power off to the receiver. And repeat step 1 and 2.
NOTE: Remove the batteries if not used for long periods of time to
prevent damage to the hand held remote.
FUNCTIONS OF TRANSMITTER
- Press and release instantly to turn on or off ceiling fan
- Press and release instantly to set 1~5 fan speed.
- Press for forward/reverse airflow of ceiling fan.
- ON/OFF – Press and release immediately to turn on or off light. DIMMER- Press and hold to dim or brighten lights to the desired level and release.
- : Press for select light color, 2700K, 3000K or 4000K. Installation of Transmitter Wall Mount Holder with Two screws.
To assure continued FCC compliance
Any changes or modifications not expressly approved by the grantee of this
device could void the user’s authority to operate the equipment.
FCC ID： 2AQZU-18028
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
IC WARNING
This device contains licence-exempt transmitter(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.