Satellite Electronic 18038 Ceiling Fan Remote Control User Manual

Satellite Electronic 18038 Ceiling Fan Remote Control

Product Information

The Ceiling Fan Remote Control is a hand-held device designed to control the speed and light of a ceiling fan. The remote control uses radio frequency signals to communicate with the fan receiver installed in the ceiling fan. The remote control operates on two AAA batteries (not included) and has a range of approximately 30 feet.

Functions of Transmitter

• Press 1 Key: The receiving machine can control FAN to do OFF action.
• Press 2 Key: Open the fan on the receiving machine 1 speed.
• Press 3 Key: Open the fan on the receiving machine 2 speed.
• Press 4 Key: Open the fan on the receiving machine 3 speed.
• Press 5 Key: Light can be controlled by remote host and ON/OFF/DIMMER.
• Press 6 Key: Light can be controlled by remote host and colour.

Safety Instructions

• Remove batteries if not used for long periods of time to prevent damage to the remote control.
• Batteries must be removed from the transmitter before it is scrapped, and the batteries shall be disposed of safely.

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment.

IC Warning

This device contains license-exempt transmitter(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Product Usage Instructions

1. Open the battery compartment on the back of the remote control and insert two AAA batteries.
2. Install the receiver unit into the ceiling fan according to the manufacturer’s instructions.
3. Turn on the main power supply to the ceiling fan.
4. To turn on the fan, press any speed key (2/3/4).
5. To turn off the fan, press the off key (1).
6. To control the light, press the light key (5/6). The light can be turned on/off or dimmed using the remote control.
7. Keep the remote control in a safe place when not in use.
8. If the remote control is not used for an extended period, remove the batteries to prevent damage to the remote control.

LEARNING PROCESS

NOTE: The Hand Held Remote Control is equipped with a learning ID function which has code combinations to prevent potential interference from other remote units.

• Step: 1. Install the batteries AAA 1.5V*2 PCS in transmitter. Within 30 seconds of turning the Receiver AC power ON, press the transmitter LEARN button

• Step: 2. Hold LEARN button about 3 seconds, once the receiver has detected the ID, the light of ceiling fan will be blinking twice and the fan turn on low speed. This will indicate the receiver has learned the ID that was previously selected on the transmitter.
  Note: After the AC power is on, do not press any other buttons on the transmitter before learning ok. Because doing so will cause the procedure to fail.

• After completing the steps above, you should be able to operate the ceiling fan and light. If the ceiling fan is not responding to the transmitter, please turn the power off to the receiver and repeat step 1 and 2.

• Remove the batteries if not used for long periods of time to prevent damage to the hand held remote. The batteries must be removed from the transmitter before it is scrapped and the batteries shall be disposed of safety.

FUNCTIONS OF TRANSMITTER

1. Press KEY，The receiving machine can control FAN to do OFF action.
2. Press KEY， Open the fan on the receiving machine 1 speed
3. Press KEY，Open the fan on the receiving machine 2 speed
4. Press KEY，Open the fan on the receiving machine 3 speed
5. Press KEY， light can be controlled by remote host and ON/OFF/DIMMER.
6. Press KEY， light can be controlled by remote host and colour

To assure continued FCC compliance

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

CAUTION:
To assure continued FCC compliance:

• Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment.
• FCC ID：2AQZU-18038
• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IC WARNING
This device contains licence-exempt transmitter(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

References

• 百度翻译-200种语言互译、沟通全世界！

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>