MIERES WYW368430925 Tufted Bench Ottoman Instruction Manual
- June 4, 2024
- MIERES
Table of Contents
WYW368430925
TUFTED BENCH OTTOMAN
ASSEMBLY INSTRUCTIONS
Instruction Manual
General Guidelines
- Please read the following instruction carefully and use the product accordingly.
- Please keep this manual and hand it over when you transfer the product.
- This summary may not include every detail of all variations and considered steps. Please contact us when further information and help are needed.
Warning
- During assembly, keep all small objects out of the reach of children, as they may be fatal if swallowed or inhaled.
- Never allow children to climb or play around the product to protect children from injury caused by the tilting of the product.
- To avoid the potential dangers of suffocation, please keep all parts and packaging away from children.
Component
| Letter (number) | Part | Design | Quantity |
|---|---|---|---|
| 1 | Bench Seat | | X1
2| Bench Leg| 
| l X4
H| Screw M5*L30mm| | X16
ATTENTION
- When you begin each step, please check carefully whether you have taken the correct parts, so as not to use the wrong parts and cause the wrong assembly.
- We recommend that you do not rush to tighten the screws. It is best to tighten the screws to two-thirds first, after all the steps are installed and the position is well adjusted, then tighten each screw in turn.
Step 1
During the assembly, please first half-tighten all
the screws into the holes.
After all the screws are set, fully tighten them.
Step 2
During the assembly, please first half-tighten all the screws into the holes.
After all the screws are set, fully tighten them.
Tips:
A screwdriver is not included in the package, please use a straight
screwdriver to fix the bench legs and seat cushion.
**Notes**
- The product is intended for indoor use only. The product must be assembled and used under the provisions of the manual. Personal injury and/or damage to the product may occur if products are used outside of their intended purposes and/or if products have been changed/modified from their original design.
- The seller does not assume any responsibility or liability concerning any injury/damage caused by incorrect assembly or improper use.
- Avoid long-term exposure to humid environments to prevent mildew.
- Keep the product away from fire sources and high temperatures.
- Do not expose the product to direct sunlight.
- Do not place any hot objects on the surface of the product.
- If there are any defective or missing parts after unpacking, please cease assembly immediately and contact us.
- Please assemble the item on a spacious surface and do not place the unwrapped product directly on the ground to avoid product damage
- Please do not stand or sit on the wooden boards.
- Please wear gloves during the assembly and/or disassembly process to avoid scratches from any sharp edges.
- Please match the corresponding part and fitting based on the part number in the manual.
- If the part does not match with the fitting, please check the piece as specified in this manual.
- During assembly, first loosely align all screws with the corresponding pre-drilled holes and then tighten the screws one by one.
- Periodically inspect screw tightness while the product is in use. If necessary, retighten to ensure structural integrity.
- If you accidentally spill water or another liquid on the surface, immediately wipe clean with a dry towel.
- Please keep the product away from sharp, pointed objects and corrosive substances to prevent product damage. Please place this item on the level solid ground during use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>