Satellite Electronic 18019 DC Power Ceiling Fan Remote Control Instructions
- June 5, 2024
- Satellite Electronic
Table of Contents
DC POWER CEILING FAN REMOTE CONTROL MANUAL
LEARNING PROCESS
NOTE: The Hand-Held Remote Control System is equipped with a learning
frequency function that has code combinations to prevent potential
interference from other remote units.
Step: 1. Install the DC1.5V/AAA 2pcs batteries. Within 30 seconds of
turning the receiver’s AC power ON. Press the transmitter’s “LEARN” button.
Step: 2. Hold the “LEARN” button for over 5 seconds, once the receiver
has detected the frequency, the receiver will make a sound, Bi Bi, twice.
This will indicate the receiver has learned the frequency that was previously
selected on the transmitter.
NOTE: After the AC power is on, do not press any other button on the
transmitter before pressing the “LEARN” button. Because doing so will cause
the procedure to fail.
After completing the steps above, you should be able to operate the ceiling
fan and light. If the fan is not responding to the transmitter, please turn
the power off to the receiver. And repeat step 1 and 2.
NOTE: Remove the battery if not used for long periods of time to prevent damage to the handheld remote.
FUNCTIONS OF TRANSMITTER
: Turn on a fan and set fan speed.
: Turn off the ceiling fan.
-“F/R”: Hold this button for 2 seconds to set the fan wind direction up or down.
Natural breeze: Fan speed will modulate to simulate a natural breeze
Press and turn the light on or off.
DIMMER-Press and hold to dim or brighten light to the desired level and
release. (Tungsten or dimmer-able LED.)
Installation of Transmitter Wall Mount Holder with Two screws.
To assure continued FCC compliance:
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
To assure continued FCC compliance:
Any changes or modifications not expressly approved by the grantee of this
device could void the user’s authority to operate the equipment.
FCC ID：2AQZU-18019
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>