Satellite Electronic 18024 Ceiling Fan Remote Controller Instruction Manual
- June 6, 2024
- Satellite Electronic
Table of Contents
Satellite Electronic 18024 Ceiling Fan Remote Controller
LEARNING PROCESS
NOTE: The Hand Held Remote Control System is equipped with a learning frequency function which has code combinations to prevent potential interference from other remote units. The frequency on your Receiver and Transmitter units have been preset at the factory. We recommend changing the frequency while installing your ceiling fan instead of using the initial frequency set by the factory. Please use a small size tool to change the code switch setting.
- Step: 1 Open the remote battery cover and install DC12V,23A*1pc battery
- Step: 2 Within 30 seconds of turning the Receivers AC power ON.
- Step: 3 Press and hold remote any key for over 3 seconds, once the receiver has detected the frequency, Then fan turn off and light blink 3 times. This will indicate the receiver has learned the frequency that was previously selected on the transmitter.
NOTE: Remove the battery if not used for long periods of time to prevent damage to the hand held remote.
FUNCTIONS OF TRANSMITTER
When pressing remote button, the LED indicator would be on. If you press remote button and LED indicator would not be on, you should change new DC12V,23A*1pc battery.
To assure continued FCC compliance
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. –Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. –Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
To assure continued FCC compliance:
Any changes or modifications not expressly approved by the grantee of this
device could void the user’s authority to operate the equipment.
FCC ID:2AQZU-18024
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IC: 25524-TR35F
IC WARNING
This device contains licence-exempt transmitter(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>