kogan LED TV 7 40″ User Manual
- June 7, 2024
- Kogan
Table of Contents
Series 7 40″ QF7000 LED TV
KALED40XXXRA
USER MANUAL
Safety Instructions
General Safety Instructions
Risk of electric shock. DO NOT OPEN!
Do not attempt to service the television yourself, as opening or removing the
covers may expose you to dangerous voltage or other hazards. Refer all
servicing to the Kogan customer support team.
To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. The television should not be exposed to dripping or splashing, and no liquid-filled objects such as vases should be placed on the case.
In the event of smoke, strange noises or a strange smell from the unit, you
should follow these steps:
- Turn off the unit
- Disconnect the power plug from the power
- Contact the Kogan customer support Never attempt to make repairs yourself.
Never push objects of any kind into the set through the cabinet slots as they may touch dangerous voltage points or short-circuit parts that could result in a fire or electric shock. Never spill any liquids onto the set. Use special caution in households where children are present. The television is not suitable for children under 4 years old to operate.
Power supply cords should be routed safely to prevent dangers due to damaged cords. The mains plug is the main disconnect method, so it should be easily accessible and not be obstructed during use.
To avoid fires, no naked flame sources such as lit candles or burning incense should be placed onto the casing of the television.
Do not pull the plug out of a power outlet by pulling on the power cable. Always grasp the plug and pull.
Never touch the plug with wet hands.
An outside antenna system should not be located in the vicinity of overhead
power lines or other electric light or power circuits.
When installing an outside antenna system, extreme care should be taken to
keep from touching such power lines or circuits, as contact with them may be
fatal.
Always turn the set off when it is not being used. Unplug the television from the power outlet when it will not be used for a long time or when there is an electrical storm. Never touch the antenna cable during a lightning storm.
Excessive volume from earphones and headphones can cause permanent hearing loss. Always monitor the volume of noise from these devices, especially when children are using them.
Installation
Ventilation should not be impeded or limited by covering the ventilation slots with items such as newspapers, tablecloths, curtains, etc.. At least 1Ocm of space should be left around the apparatus for sufficient ventilation.
The television should be situated away from heat sources such as radiators, heaters, stoves, or other products that produce heat. Place the television in a position where the screen is not exposed to direct sunlight. It is best to have soft indirect lighting while watching, and you should avoid a completely dark viewing environment and reflections to avoid eye fatigue. Keep the product away from high magnetic fields (such as near an amplifier speaker) to avoid affecting the tint.
Do not place the television on an unstable table, stand or shelf. The set may fall, causing serious injury as well as damage to the television itself. If moving the television on a cart, move the unit with care as sudden stops and starts may cause the television to overturn.
Do not place this television near water, for example near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a damp basement, etc..
When moving the television to a warm location from a cold location, allow some time for any dew or condensation inside the television to evaporate fully before you turn the unit on.
To prevent injury, the television must be securely attached to the floor/wall in accordance to the supplied installation instructions.
Cleaning
Unplug the television from the power supply before cleaning. Do not use any liquid cleaners or harsh chemicals. Use a soft, damp cloth.
General Description
- Zero X radiation complies to green environment protection Auto tuning and fine-tuning. One PC VGA input socket.
- One YpbPr input
- Three HDMI input sockets (HDMI 4)
- One composite video input
- One audio input
- USB
- Headphone support
Multi-language on-screen display
Specifications & Accessories
Specifications
Model | KALED4OXXXRA |
---|---|
Display screen size | 4O” Diagonal 192O x 1O8O |
Maximum Resolution | AC 11O-24OV – 5O/6OHz PAL/SECAM: BG, DK, I DVB-T |
Power Supply | KALED4OXXXRA |
Tv Receive System | 4O” Diagonal 192O x 1O8O |
Frequency Range | DTV:VHF(174MHz-23OMHz} UHF(474MHz-862MHz |
Video in | PAL/NTSC |
Antenna Input Impedance | 75ohm |
Remote power input | DC 3V (Two AAA batteries) |
Max power consumption | 70 w |
Operating temperatures | O°C – 4O°C |
Accessories
Remote Control
Overview
The buttons on the right panel control your TVs basic features, including the on-screen menu. To use the televisions more advanced features, you must use the remote control.
- Press VOL+ or VOL- to increase or decrease the
- Press CH+ or CH- to scan through
- Press MENU to bring the main menu up onto the
- Press SOURCE to select the input
- Press STANDBY to turn standby mode on or
- POWER INDICATOR: shows red in standby, then green when the TV is switched
- REMOTE SENSOR: an infrared sensor for the remote.
- HEADPHONE: 3.5mm audio jack
- PC AUDIO: Connect the audio output jack of a
- VGA: Connect a VGA cable from a computer for
- COMPONENT: Connect video cables from a component
- Coax: Coaxial output for digital
- RF: Antenna connection
- HDMI: Connect HDMI HDMI cables carry both video and audio.
- USB: Insert a USB storage device to view photos and listen to
- COMPOSITE: Connect the audio and video cables from a DVD or VCR
Remote Control
- STANDBY: Turns the TV on or off.
- SOURCE: Press to cycle through the input source.
- NUMBER BUTTONS(0-9): Press 0-9 to select a TVchannel directly when you are watching TV. The channel will change after 2
- FAV: Press this button to show the favourite channel menu on your TV screen when you watch TV programs.
- //: Returns to the previous chanal.
- PMODE: Selects various preset picture
- SLEEP: Select amount of time.Let your TV turn off automatically.
- SMODE: Selects various preset sound settings.
- TV/RADIO: Press to select TV or Radio mode.
- DISPLAY: Pressto display the source and channel’s information.
- THUMBSTICK//y/K/d/OK): This allows you to navigate the on-screen menus and adjust the system settings to your preference
- MENU: Brings up the main TV menu on the screen.
- EXIT: Press this button to exit the on-screen display.
- MUTE: Turn the sound off from the TV.
- EPG: Launches the EPG(Electronic Program Guide) in DTV mode.
- VOL(+)/(-): Increase or decrease the sound level.
- CH (+)/(-): Go through the channel list.
- Media: Press this button to return to the media main menu.
- AUDIO: Press this button you can choose different audio system.
- T.SHIFT: In DTV mode, press to execute the time shift function.
- ASPECT: Press this button to change the aspect of your tv.
- REC Press this button to recoard
- 23.HOLD: Press this button to freeze or unfreeze the teletext screen you are viewing.
- REVEAL: Press this button to show or hide text, for example, a text quiz.
- SUBTITLE: Press this button to show subtitles for the program you are watching, press again to hide the subtitles
- TEXT: Press this button to switch Teletext on or
- To play/pause To stop the playback To play in fast rewind mode To play in fast forward mode To restart the current chapter To advance forward to the next chapter
- INDEX: Request index page when index link is valid.
- To switch the dialogue at the button of the screen(on/off)
- RED-GREEN YELLOW BLUE KEY
- Press the buttons according to the colour displaying on the screen to enter.
Battery Operations
1 — Open the battery cover on the rear of the remote.
2 — Insert 2 x AAA batteries, ensuring that the polarity markings match the
instructions in the battery compatment.
3 — Replace the battery cover.
Basic Operation
Changing the Input Source
Press SOURCE to select the input source. Press to cycle through the input sources, and press OK to confirm your selection. Press EXIT to quit.
Navigating the Menu
Before using the TV, follow the steps below to learn how to navigate the menu in order to select and adjust different functions. The access steps may differ depending on the menu you are in at the time.
- Press MENU to display the main
- Press to cycle through the main
- Press to select the desired sub
- Press OK to access the
- Press to select the desired The adjustment in the OSD may differ depending on the selected menu.
- Press MENU to return to the previous
- Press EXIT to exit from the
Notes:
- When an item in the MENU is displayed in grey, it means the item is not available or cannot be adjusted in the current menu or submenu.
- Buttons on the TV have the same function as the corresponding buttons on the remote This manual will focus on the operations using the remote control.
Menu Operation
**Picture Menu
**
Select a type of picture to suit your viewing requirements.
You can choose to edit the Picture Mode, Brightness, Contrast, Sharpness,
Saturation, Hue, Colour Temp, Aspect Ratio and Advanced Settings.
Sound Menu
Select the type of sound to suit your viewing requirements.
You can change the values of Treble, Bass and Balance. You can change the
status of Sound Mode, Surround Sound, EQ Setting, AVL, SPDIF, Audio
Description and Sound Type.
Channel Menu
Make changes to the channels to suit your viewing requirements.
You can edit Auto Scan, Manual Tuning, Auto Channel Update, Channel Edit,
Favourites and Signal Information.
Note: some adjustment options are only available in DTV mode.
Lock System Menu
Select the type of lock to suit your viewing requirements.
You can change the status of Enable, Channel Locks, Parental Ratings, Lock
Keypad, New Password, Clear Lock and Hotel Mode. Default password: OOOO
Setup Menu
Select the type of setup to suit your viewing requirements.
You can change the status of OSD Language, Audio Languages, Subtitle,
Teletext, Blue Screen, Time Settings, PVR Settings, First Time setup, OAD,
Reset and Software Update (USB).
Note: some adjustment options are only available in DTV mode.
Media Operating Interface
This screen is available in menu mode. You can access PHOTO, MUSIC, MOVIE and TEXT modes.
Please make sure you have your USB storage device plugged in.
Connections
PC and Audio Connection
- Turn the power to your LED TV and computer
- Connect a 15-pin D-sub RGB (VGA) cable to the RGB output of your computer and the other end to the VGA input in the rear of your
- Turn the power to your LED TV and computer
- Select PC using the SOURCE button on the front of the LED TV, or directly by pressing the SOURCE button on the remote.
Video and Audio Connection
- Turn the power to your LED TV and DVD player
- Connect the VIDEO jack on the rear of your DVD player to the VIDEO on the rear of your
- Connect the R (red colour) and L (white colour) audio connectors on the rear of your DVD to the AV audio connections in the side of your LED
- Turn the power to your LED TV and computer
- Select AV using the SOURCE button on the front of the LED TV, or directly by pressing the SOURCE button on the remote control.
YPBPR and Audio Connection
- Turn the power to your LED TV and DVD player off.
- Connect the y (green), Pb (blue) and Pr (red) connectors to the rear of your DVD player to the corresponding YpbPr (black) connector in the Analog component HD group in the rear of the TV.
- Turn the power to your LED TV and computer on.
- Select Component Analog HD using the SOURCE button on the front of the LED TV, or directly by pressing the SOURCE button on the remote Control.
HDMI Connection
- Turn the power to your LED TV and DVD player off.
- Connect a HDf1I cable to the HDMI output of your DVD player, then the other end to the HDMI input in the rear of your LED TV.
- Turn the power to your LED TV and computer on.
- Select Digital HD using the SOURCE button on the front of the LED TV, or directly by pressing the SOURCE button on the remote Control.
Antenna Connection
- Turn the power to your LED TV off.
- Connect a coaxial (RF} connector from your antenna, cable or cable box to the TV connector in the rear of your LED TV.
- Turn the power to your LED TV and computer on
- Select TV using the SOURCE button on the front of the LED TV, or directly by pressing the SOURCE button on the remote control.
USB Connection
Headphone Connection
You can connect a headphone to your TV if you wish to watch a program without disturbing people around you. You can do so by inserting a headphone with a standard 3.5mm audio plug into the audio jack in the back of the TV.
Notes:
- Connect headphones with the sound down low and increase if required. Prolonged listening through some headphones at high volume settings can result in hearing
- You will not receive any sound from the TV speakers when headphones are connected to the LED
Connection Notes
- PC Settings in the PICTURE menu is available when the input is PC mode
- SCART/HDf JI/AV/YPbPr modes have no CHANNEL
- Parental Rating and Channel locks are ONLY available in DTV
Troubleshooting
If you have any problems with your television, please check the suggested solutions below, as these issues may be caused by improper adjustment/setup rather than a malfunction with the unit. If the problem persists, please contact the Kogan customer support team.
Problem | Possible Solution |
---|---|
Poor picture and sound quality | • Try a different channel |
• Adjust the antenna Check all connections
No picture or sound in TV status| • Try another channel
•Press the TV/AV button Make sure TV is plugged in Check the antenna
connection
No sound, or sound is too low at maximum volume| Check the volume settings on
any external speakers connected to your television
•Adjust the TV volume accordingly Check that MUTE hasn’t been turned on
No colour, wrong colour or tints| •I take sure the program itself is broadcast
in colour
• Select the picture menu, then adjust the colour and tint submenus
Picture rolls vertically| • Check all connections
Blurred or snowy picture, distorted sound| Check direction, location and
connections to your antenna
•Issues may be caused by use of an indoor antenna
Remote control malfunctions| •Replace remote control batteries
•Check battery terminals
• Remote is out of range, move closer to TV
•Confirm there is no obstructions between remote and TV
• I take sure power cord is plugged in
Image is not centered on the screen| • Adjust the horizontal and vertical
position
If you have any questions or concerns regarding the use of this TV, please contact the Kogan.com customer support team.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>