BUFFALO DA564/DA565/DA566/DA567 Hot Dog Warmer Instruction Manual

Hot Dog
Warmer
Instruction manual

Model :DA564/DA565/DA566/DA567

Safety Tips

• Position on a flat, stable surface.

• A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.

• Consult Local and National Standards to comply with the following:
  – Health and Safety at Work Legislation
  – BS EN Codes of Practice
  – Fire Precautions
  – IEE Wiring Regulations
  – Building Regulations

• DO NOT immerse the appliance in water.

• DO NOT clean with jet/pressure washers.

• DO NOT move or carry the appliance when it is switched on.

• DO NOT operate the appliance without water in the water dish.

• Suitable for indoor use only.

• Always switch off and disconnect the power supply to the appliance when not in use.

• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.

• If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician in order to avoid a hazard.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• Caution! Hot surface!

• BUFFALO recommends that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection,  Polarity Test, Earth Continuity, Insulation Continuity, and Functional Testing.

• BUFFALO recommends that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your BUFFALO product.
Product Description

• DA564 – Hot Dog Warmer
• DA565 – Hot Dog Warmer with 2 pins
• DA566 – Hot Dog Warmer with 4 pins
• DA567 – Hot Dog Warmer with 6 pins

Pack Contents
The following is included:

• Hot Dog Warmer
• Glass Warmer Jar & Lid
• Instruction manual
• Hot Dog Basket
• Water Dish

BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.

Installation

• Remove all packaging, taking care to dispose of all polythene bags safely.
• Check the product for any transit damage, do not use if there is damage to the product or accessories.
• Wipe bread roll spikes to remove any transit or manufacturing residues.
• Wash the glass jar, lid, hot dog basket, and water dish, in warm soapy water, then dry thoroughly.
• Insert Water Dish into the Hot Dog Warmer body and then add water above the MIN fill indicator (200ML) or to a capacity of 80% of the Dish.
• Place the Glass Jar over the Water Dish, place the Hot Dog Basket into the Glass Jar and fit Lid to the Jar.

Control panel

Operation

1. Fill Basket with Hot Dogs, place the basket in the jar, and put the lid on the jar.
2. Connect the appliance to the mains power supply.
3. Turn on the ON/OFF switch for the water dish.
4. Set the temperature control knob to the desired setting. The appliance begins to heat up.
5. When water is being heated, the indicator light will come on until the set temperature is reached, then the indicator light will go out. The power/heating element will come back on when the temperature of the water drops, the indicator light will come on and heating will continue until the set temperature is reached again.
6. Remove hot dogs from the jar as required.
7. Bread rolls can be warmed on the pins. Carefully push the roll down onto the pin then turn on the corresponding/OFF switch to warm.

Thermal Protection Reset Button

• This appliance is fitted with thermal protection device to protect the unit from damage due to overheating, low water, etc. The RESET BUTTON is located on the rear of the unit.
• If the unit overheats, allow cooling then reset by removing the cover and pressing the button.

Cleaning, Care & Maintenance

• Before cleaning takes place, the Warmer should be disconnected from the electricity supply by removing the plug from the socket.
• Do not attempt to clean the warmer or parts until they have completely cooled.
• Water Dish, Glass Jar, and Lid should be washed in soapy water, then thoroughly rinsed after every session of use.
• Other areas of the Warmer should be wiped down with a clean, damp cloth, or using a food-safe antibacterial cleaner.

Troubleshooting

Technical Specifications

Model| Voltage| Power| Current| Dimensions hxwxdmm| Weight
---|---|---|---|---|---
DA564| 220-240V—,50/60Hz| 450W| 1.9A| 370 x 340 x 340| 5.5Kg
DA565| 220-240V—,50/60Hz| 550W| 2.4A| 370 x 410 x 340| 7kg
DA566| 220-240V—50/60Hz| 650W| 2.8A| 370 x 550 x 340| 9kg
DA567| 220-240V—,50/60Hz| 750W| 3.2A| 370 x 670 x 340| 11kg

Electrical Wiring

This appliance is supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:

• Live wire (colored brown) to the terminal marked L
• Neutral wire (colored blue) to the terminal marked N
• Earth wire (colored green/yellow) to terminal marked E

This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required, they must be readily accessible.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
BUFFALO products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to change specifications without notice.

DECLARATION OF CONFORMITY

Conformiteitsverklaring

Hotdog warmer
Hotdog warmer with 2 pins
Hotdog warmer with 4 pins
Hotdog warmer with 6 pins| DA564 (& -E)
DA565 (& -E)
DA566 (& -E)
DA567 (& -E)
Application of Territory Legislation & Council Directives(s)| Low Voltage Directive (LVD) – 2014/35/EU
Electrical Equipment (Safety) Regulations 2016
EN 60335-1:2012 +A11:2014
EN 60335-2-48:2003 +A1:2008 +A11:2012
EN 62233:2008 Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU – recast of 2004/108/EC
Electromagnetic Compatibility Regulations 2016 (S.I. 2016/1091)
EN 55014-1:2017
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013 Restriction of Hazardous Substances Directive (RoHS) 2015/863 amending Annex II to Directive 2011/65/EU
Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulations 2012 (S.I. 2012/3032)
Producer Name| Buffalo

I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s) and Standard(s).

2](https://manuals.plus/wp-content/uploads/2021/09/BUFFALO-DA564Hot-Dog- Warmer-signature-2.jpg)
Full Name| Ashley Hooper

| Eoghan Donnellan
Position| Technical & Quality Manager| Commercial Manager/ Importer
Producer Address| Fourth Way, Avonmouth, Bristol, BS11 8TB
United Kingdom| 42 North Point Business Park New Mallow Road
Cork Ireland

+44 (0)845 146 2887
http://www .buffalo-appliances.com/

DA564-DA567_ML_A5_v3_20210521

Documents / Resources

| BUFFALO DA564/DA565/DA566/DA567 Hot Dog Warmer [pdf] Instruction Manual
Hot Dog Warmer, DA564, DA565, DA566, DA567
---|---

References

• Buffalo Home Page

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>