BUFFALO CT938 Single Milkshake Maker Instruction Manual

June 3, 2024
BUFFALO

BUFFALO CT938 Single Milkshake Maker

BUFFALO-CT938-Single-Milkshake-Maker-product

Safety Tips

  • Position on a flat, stable surface.

  • A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.

  • Consult Local and National Standards to comply with the following:

    • Health and Safety at Work Legislation
    • BS EN Codes of Practice
    • Fire Precautions
    • IEE Wiring Regulations
    • Building Regulations
  • DO NOT use jet/pressure washers to clean the appliance.

  • DO NOT immerse the appliance in water.

  • This appliance is only suitable for mixing beverages. Do not use this appliance for anything other than its intended use.

  • Always switch off and disconnect the power supply to the appliance when not in use.

  • Not suitable for outdoor use.

  • Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.

  • If the power cord is damaged, it must be replaced by an BUFFALO agent or a recommended qualified technician in order to avoid a hazard.

  • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

  • Children should be supervised to ensure that they do not play with the appliance.

  • Do not let cord hang over edge of table or counter, or touch hot surfaces.
    CT938_CY423_ML_A5_v3_20210521.indb 2 2021/5/21 13:393 UK

  • Keep hands and utensils out of the mixing cup while motor is
    running to prevent severe personal injury and / or damage to the appliance.

  •  Never try to remove agitators while cup is sitting on the micro switch plate.

  • Do not operate with loose or damaged agitators.

  • Do not place cup on to microswitch plate with On/Off switch in the On position ( I  or  II  position).

  • Please note milk may double in volume after mixing so fill the cup accordingly.

  • When using the Tritan jug please use the Tritan agitators supplied.
    ( Note:  The Tritan jug and agitators are sold separately.)

  • Do not leave appliance unattended while in use.

  •  BUFFALO recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection,
    Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.

  • BUFFALO recommend that this product is connected to a circuit protected by an appropriate  RCD  (Residual Current Device).

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your BUFFALO product.

Product Description

  • CT938  – Buffalo Single Milkshake Maker
  • CY423  – Buffalo Double Milkshake Maker

Pack Contents

The following is included:

  • BUFFALO Milkshake Maker
  • Mixing cup
  • Instruction manual

BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.

Operation

  • Model: CY423

BUFFALO-CT938-Single-Milkshake-Maker-fig-1

On/Off switch: Up position for Low speed ( I ); Down position for high speed ( II ); Middle position for turning off  (0).

Mixing

Before use, ensure to

  • Clean all removable parts thoroughly.
  • Turn off On/Off switch (0 position).
  1. Plug in the appliance.
  2. Place ingredients into mixing cup. .
  3.  Locate cup on to the micro switch plate.
  4. Turn on appliance by setting the On/Off switch to desired speed setting.

Note

  • Do not run the appliance excessively for more than 3 minutes at a time to avoid overheating activation. In case of overheating, the appliance will stop work automatically. Let it cool down sufficiently before restart.
  • With the safety micro switch, the appliance will turn off automatically once the mixing cup is released from the micro switch plate.
  • Before removing cup, ensure to turn off appliance using On/Off switch and let the motor come to a complete stop.

Cleaning, Care & Maintenance 

  • Always disconnect from power supply before cleaning.
  • Always allow to cool before cleaning.
  • Let the motor come to a complete stop before removing the cup.
  • The cup is NOT dishwasher proof!
  • Use warm, soapy water and a damp cloth to clean the cup.
  • The agitators can be removed for thorough cleaning. Or, with the agitators in place, you can run the appliance with clean water in the cup for seconds.
  • Dry thoroughly after cleaning.
  • A BUFFALO dealer or qualified technician should carry out repairs if required

Warning: Do not allow any water to spill into the body of the appliance when cleaning.

Troubleshooting

Fault Probable Cause Solution
The unit is not working The unit is not switched on Check the unit is

plugged in correctly and switched on
Plug or lead is damaged| Call BUFFALO agent or qualified Technician
Fuse in the plug has blown| Replace the plug fuse
Power supply| Check power supply
Cup not located properly| Relocate cup

Technical Specifications

Model| Voltage| Power| Current| Cup Capacity| Dimensions h x w x d mm| Weight
---|---|---|---|---|---|---
CT938| 220-240V~
50/60Hz| 80W| 0.34A| 750ml| 510 x 170 x 170| 3.45kg
CY423| 220-240V~
50/60Hz| 80W+80W| 0.34A| 2 x 750ml| 510 x 360 x 170| 7kg

Electrical Wiring

  • This appliance is supplied with a 3 pin BS1363 plug and lead.
  • The plug is to be connected to a suitable mains socket.

This appliance is wired as follows:

  • Live wire (coloured brown) to terminal marked L
  • Neutral wire (coloured blue) to terminal marked N
  • Earth wire (coloured green/yellow) to terminal marked E
  1. This appliance must be earthed.
  2. If in doubt consult a qualified electrician.

Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required, they must be readily accessible.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.

BUFFALO parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities. BUFFALO products have been approved to carry the following symbol

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO. Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to change specifications without notice.

DECLARATION OF CONFORMITY

Equipment Type Model
Single Milkshake Mixer Double Milkshake Mixer CT938 (& -E) CY423 (& -E)

Application of Territory Legislation & Council Directives(s)

| Low Voltage Directive (LVD) 2014/35/EU Electrical Equipment (Safety) Regulations 2016 EN 60335-1:2012 +A11:2014

EN 60335-2-64:2000 +A1:2002

EN 62233:2008


Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU recast of 2004/108/EC Electromagnetic Compatibility Regulations 2016 (S.I. 2016/1091)

EN 55014-1:2017

EN 55014-2:2015

EN IEC 61000-3-2:2019

EN 61000-3-3:2013 +A1:2019


Restriction of Hazardous Substances Directive (RoHS) 2015/863 amending Annex II to Directive 2011/65/EU

Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012 (S.I. 2012/3032)

Producer Name| Buffalo

I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s) and Standard(s).

CT938_CY423_ML_A5_v3_20210521

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals