BUFFALO DB170 Waffle Maker Instruction Manual

BUFFALO DB170 Waffle Maker Instruction Manual

Model: DB170

Safety Instructions

• Position on a flat, stable surface.

• A service agent/qualified technician should carry out
  installation and any repairs if required. Do not remove any
  components on this product.

• Consult Local and National Standards to comply with the
  following:
  – Health and Safety at Work Legislation
  – BS EN Codes of Practice
  – Fire Precautions
  – IEE Wiring Regulations
  – Building Regulations

• Some surfaces become hot during operation – take care when using the appliance! 

• DO NOT immerse the appliance in water.

• DO NOT clean with jet/pressure washers.

• DO NOT carry when hot.

• DO NOT leave the appliance unattended during operation.

• DO NOT obstruct or cover the appliance in any way when in use.

• During and after cooking, the unit is still hot. Never touch the surface to avoid scalding.

• Not suitable for outdoor use.

• Always switch off and disconnect the power supply to the appliance when not in use.

• This appliance must only be used in accordance with these instructions and by persons competent to do so.

• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.

• If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician in order to avoid a hazard.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• BUFFALO recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.

• Always use the black handles to lift the plates.

• BUFFALO recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

Product Description

• DB170 – Buffalo Waffle Maker

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your BUFFALO product.

Pack Contents

The following is included:

• BUFFALO Waffle Maker
• Waste tray
• Instruction manual

BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage.

Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.

Operation

Cooking

1. Close the plates.
   • Note: It may be necessary to slightly grease the plates with cooking oil before cooking depending on the foodstuff.

2. Set the thermostat to the desired temperature (100°C-300°C) and turn the appliance On. The power indicator light turns on.
   • Note: 185°C is suitable for general waffle cooking.

3. The power indicator light turns Off when the appliance has reached the set temperature.

4. Lift the top plate and place the waffle mix on the bottom plate.

5. Lower the top plate.

Using the timer
The digital timer with audible alarm can be set from 1 second to 15 minutes. The timer provides an audible alarm after the set time expires. It provides no electrical control over the unit.

• START/STOP: Press START/STOP to start timer, press again to stop. The timer will provide an audible alarm after the set time. The alarm will beep 10 times and the display will continue to flash until timer is reset (press the START/STOP button).

• UP: Press UP to add extra time.

• DOWN: Press DOWN to reduce time.

• PROGRAM: There are a total of 6 programmable timer settings. The default factory program settings are given below.

• To change the length of a program select the program you want to change by scrolling using the PROGRAM button.
• Adjust the program time by using the UP and DOWN buttons. Press START/STOP to commence the count-down. The new program time will be automatically stored.
• If the unit is left without power for more than 24hrs the timer settings will revert to the factory defaults.

Cleaning, Care & Maintenance

If grease is permitted to accumulate, it will begin to carbonise into a hard substance that is extremely difficult to remove. To prevent this, follow the cleaning steps below:

• Always turn OFF the appliance and disconnect from the power supply before cleaning.
• Allow the appliance to cool before cleaning, but for best results clean the plates when they are still slightly warm.
• Use warm, soapy water and a damp cloth to clean the exterior of the appliance.
• Take care when using scrapers to remove cooking residues as they can damage the cooking surface.
• Dry thoroughly after cleaning.
• A BUFFALO dealer or qualified technician should carry out repairs if required.

Warning: Do not use steel wool as it may leave shards that could Contaminate  food.

Waste tray

• This appliance features a waste tray to collect any liquid or fats that run off during cooking.
• At least once a day, remove and empty the waste tray before washing with warm, soapy water.
• Warning: Do not remove the tray during or immediately after use as the contents will be hot.

Troubleshooting

Technical Specifications

Electrical Wiring

This appliance is supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E

This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.

BUFFALO parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.

BUFFALO products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to change specifications without notice.

DECLARATION OF CONFORMITY

Equipment Type •

Model •

Application of Council Directives(s)

Producer Name •

Producer Address •

I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and Standard(s).

Date •

Signature •

Full Name •

Position •

http://www.buffalo-appliances.com/

Read More About This Manual & Download PDF:

References

• Buffalo Home Page

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>