BUFFALO fd059 Compact Induction Heater 1000W User Manual

June 3, 2024
BUFFALO

fd059 Compact Induction Heater 1000W
User Manual
BUFFALO fd059 Compact Induction Heater
1000W

Safety Instructions

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your Buffalo product.

  • Position on a flat, stable surface.
  • A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
  • Consult Local and National Standards to comply with the following: – Health and Safety at Work Legislation – BS EN Codes of Practice – Fire Precautions – IEE Wiring Regulations – Building Regulations
  • Caution! Hot surface!
  • DO NOT immerse the appliance in water.
  • DO NOT leave the appliance unattended during operation.
  • DO NOT move the appliance during cooking or with hot cookware on top of it.
  • DO NOT place empty cookware on the appliance.
  • Do not place the appliance near objects that may be affected by a magnetic field such as TVs, radios, bank cards, etc.
  • Metallic objects such as knives, forks, spoons and lids should not be placed on the heating plate since they can get hot.
  • People with a pacemaker fitted should not use the appliance and keep a minimum of 60cm from the appliance during operation.
  • Keep all ventilation openings in the appliance clear of obstruction.
  • Always switch off and disconnect the power supply to the appliance when not in use.
  • Not suitable for outdoor use.
  • If the glass surface is cracked disconnect from the power supply and consult your Buffalo agent or recommended qualified technician.
  • Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
  • If the power cord is damaged, it must be replaced by a Buffalo agent or a recommended qualified technician in order to avoid a hazard.
  • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
  • Children should be supervised to ensure that they do not play with the appliance.
  • This appliance is not intended to be operated by means of an external timer or separate remote-control system.
  • BUFFALO recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Insulation Continuity and Functional Testing.
  • BUFFALO recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

Induction Cooking
Induction cooking is a very efficient method of cooking as it reduces heat loss between the pan and the atmosphere by as much as 40%. This makes it extremely energy efficient, as well as offering immediate heat-up, unlike traditional heating methods which require time to get to temperature.
The Induction cooker works by creating a magnetic field within suitable cookware, which causes an instant build-up of heat to cook the food.
Pack Contents
The following is included:

  • Induction heater
  • Instruction manual

Buffalo prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your Buffalo dealer immediately.

Installation

Place the unit on a heat-resistant surface. Avoid placing it on or close to easy flammable materials. Maintain a distance of 20cm (7 inches) between the appliance and walls or other objects for ventilation.
Cookware
Suitable cookware includes:

  • All magnetic pans such as Vogue Stainless Steel or Triwall pans.
  • Mild steel or plain steel (black iron) pans
  • Enamelled/non-enamelled cast iron and iron pans
  • Cookware diameter: 12cm – 20cm

Unsuitable cookware includes:

  • Cookware with a diameter less than 12cm
  • Ceramic or glass cookware
  • Stainless steel with no/weak magnetism, aluminium, bronze or copper cookware unless marked as suitable for induction cooking
  • Cookware with feet
  • Cookware with a rounded bottom (e.g. wok)

Operation

This appliance is intended for heating and keeping food warm in suitable chafing dishes or directly via cookware. Any other use may lead to damage of the appliance or personal injury. This appliance is also designed to suit with the Olympia chafing set (i.e. the stand and dish, with the respective purchase code FT039/FT037), the appliance can also be integrated into suitable tabletops.

  1. Place suitable cookware on to the centre of the glass plate.
  2. Connect the appliance to the mains power supply. “–” is shown and the On/Off key will lights up, indicating the appliance is now in STANDBY.
  3. Press the On/Off key ****to turn the appliance on. “ON” is shown.
  4. Press the Increase key or Decrease key to choose the suitable power level from 1 to 10.
  5. To turn appliance off, just press the On/Off key ****.

Note: If unsuitable cookware or no cookware is present the appliance will beep constantly before switching off.

Cleaning, Care & Maintenance

Disconnect from the power supply and allow the appliance to cool before cleaning.

  • Use warm, soapy water and a damp cloth to clean the appliance.
  • DO NOT use abrasive cleaners or pads.
  • Dry thoroughly after cleaning.

Troubleshooting

A qualified technician should carry out repairs if required.

Fault Probable Cause Solution
The unit is not working The unit is not switched on Check the unit is

plugged in correctly and switched on
Plug or lead is damaged| Replace plug or lead
Fuse in the plug has blown| Replace the fuse
Mains power supply fault| Check mains power supply
Unsuitable cookware| Replace with suitable cookware
“E1” on Display| Appliance has overheated| Check ventilation slots for blockage. Allow to cool before attempting to use again.
“E2” on Display| Temperature sensor is damaged| Replace temperature sensor
“E3” on Display| Input voltage is too high/low| Make sure the mains power supply is suitable for the appliance.

Technical Specifications

Model| Voltage| Power (Max.)| Current| Power lever| Dimensions Ø x H (mm)| Weight
---|---|---|---|---|---|---
FD059| 220-240V~50-60Hz| 1000W| 4.35A| 10-Jan| 245 x 68| 1.7kg

Electrical Wiring

This appliance is supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:

  • Live wire (coloured brown) to terminal marked L
  • Neutral wire (coloured blue) to terminal marked N

If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
Buffalo parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
Buffalo products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of Buffalo.
Every effort is made to ensure all details are correct at the time of going to press, however, Buffalo reserves the right to change specifications without notice.

DECLARATION OF CONFORMITY

Equipment Type Model

Application of Territory Legislation &
Council Directives(s)| Low Voltage Directive (LVD) – 2014/35/EU
Electrical Equipment (Safety) Regulations 2016
EN 60335-1:2012 +A11:2014
EN 60335-2-9:2003 +A1:2004 +A2:2006 +A12:2007 +A13:2010
EN 62233:2008
Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU – recast of 2004/108/EC
Electromagnetic Compatibility Regulations 2016 (S.I. 2016/1091)
EN 55014-1:2017
EN 55014-2:2015
EN IEC 61000-3-2:2019
EN 61000-3-3:2013
Regulation (EC) 1275/2008 – Standby and off mode power consumption (2019)
Regulation (EU) 66/2014 – Ecodesign ovens, hobs and range hoods
EN 60350-2:2013
Restriction of Hazardous Substances Directive (RoHS) 2015/863 amending Annex II to Directive 2011/65/EU
Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012 (S.I. 2012/3032)
Producer Name| Buffalo

I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s) and Standard(s).

Date 17th  December 2021
Signature

Full Name
Position| Technical & Quality Manager| Commercial Manager/Importer
Producer Address| Fourth Way,
Avonmouth, Bristol,
BS11 8TB
United Kingdom| Unit 9003
Blarney Business Park
Blarney
Co. Cork, Ireland

BUFFALO fd059 Compact Induction Heater 1000W - Qr
Codehttp://www.buffalo-appliances.com/
FD059_EN_A5_v1
2022/5/17 13:26

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals