BUFFALO L413 Coffee Jug Hotplate Instruction Manual
- June 7, 2024
- BUFFALO
Table of Contents
BUFFALO L413 Coffee Jug Hotplate
Safety Tips
- Position on a flat, stable surface.
- A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
- Consult Local and National Standards to comply with the following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
- Plates become hot during operation – DO NOT TOUCH!
- Always switch off and disconnect the power supply to the appliance when not in use.
- Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
- If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician in order to avoid a hazard.
- BUFFALO recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your BUFFALO product.
Pack Contents
The following is included:
- BUFFALO Coffee Jug Hotplate
- Instruction manual
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Operation
The two hotplates work independently of each other. To use:
- Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.
- Connect the appliance to the mains power supply.
- Place the coffee jug(s) on the hotplate(s).
- Turn the relevant power switch to the On position [I].
WARNING: DO NOT allow the coffee jug to dry out. Damage to the jug may occur.
Cleaning, Care & Maintenance
- Always turn off and disconnect the appliance from the power supply before cleaning.
- Use soapy water and a damp cloth to clean the exterior of the appliance.
- Dry thoroughly after cleaning.
Troubleshooting
Fault
|
Probable Cause
|
Action
---|---|---
The unit is not working| The unit is not switched on| Check the unit is
plugged in correctly and switched on
Plug or lead are damaged| Call BUFFALO agent or qualified technician
Fuse in the plug has blown| Replace the plug fuse
Power supply| Check power supply
Technical Specifications
Model
|
Voltage
|
Power
|
Current
|
Hotplate Diameter
|
Weight
|
Dimensions
h x w x d mm
---|---|---|---|---|---|---
L413
|
230V 50Hz
|
160W
|
0.7A
|
120mm
|
1.5kg
|
65 x 360 x 150
Electrical Wiring
This appliance is supplied with a 3 pin BS1363 plug and lead. The plug is to
be connected to a suitable mains socket.
This appliance is wired as follows:
- Live wire (coloured brown) to terminal marked L
- Neutral wire (coloured blue) to terminal marked N
- Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit. If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
BUFFALO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or
transmitted in any form or by any means, electronic, mechanical, photocopying,
recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going
to press, however, BUFFALO reserve the right to change specifications without
notice.
http://www.buffalo-appliances.com/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>