TELTONIKA RUTX10 Industrial VPN WiFi Router User Guide

: June 7, 2024
: teltonika

Table of Contents

TELTONIKA RUTX10 Industrial VPN WiFi Router
FRONT VIEW
BACK VIEW
POWER SOCKET PINOUT
HARDWARE INSTALLATION
LOGIN TO DEVICE
SETUP WIZARD
TECHNICAL INFORMATION
SAFETY INFORMATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TELTONIKA RUTX10 Industrial VPN WiFi Router

Product Image

https://wiki.teltonika-networks.com/

FRONT VIEW

BACK VIEW

POWER SOCKET PINOUT

HARDWARE INSTALLATION

Connect the power adapter to the socket on the front of the device. Then plug the other end of the power adapter into a power outlet.
Connect to the device via an Ethernet cable connected to LAN port.

To enter the router’s Web interface (WebUI), type http://192.168.1.1 into the URL ﬁeld of your Internet browser.
Use login information shown in image A when prompted for authentication.
After you log in, you will be prompted to change your password for security reasons. The new password must contain at least 8 characters, including at least one uppercase letter, one lowercase letter, and one digit. This step is mandatory, and you will not be able to interact with the router’s WebUI before you change the password.
When you change the router’s password, the Conﬁguration Wizard will start. The Conﬁguration Wizard is a tool used to set up some of the router’s main operating parameters.

SETUP WIZARD

After logging in to the router’s WebUI, you will be prompted to change the default password and the Setup Wizard will start:

Choose your time zone and sync the router’s time with the browser if needed.
Default LAN settings are recommended unless you have speciﬁc requirements for your LAN network.

TECHNICAL INFORMATION

Radio Speciﬁcations

RF technologies

| WiFI, BLE

Max RF power

| 23 dBm@WiFi, 10 dBm@BLE

Bundled Accessories S **peciﬁcations***

Power adapter

| Input: 0.6 A@100-240 VAC, Output: 12 VDC, 1.5 A, 4-pin plug

WiFi antenna

| 2400~2483.5 MHz/5150~5905 MHz, 50 Ω, VSWR<2, gain** 5 dBi, omnidirectional, RP-SMA male connector

BLE antenna

| 2400~2483.5 MHz, 50 Ω, VSWR<2, gain** 2 dBi, omnidirectional, RP-SMA male connector

*Order code dependent.
**Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for the compliance with the legal regulations. In all EU member states, operation of 5150-5250 MHz is restricted to indoor use only.

SAFETY INFORMATION

RUTX10 router must be used in compliance with any and all applicable national and international laws and with any special restrictions regulating the utilization of the communication module in prescribed applications and environments.

Hereby, TELTONIKA NETWORKS declares that this RUTX10 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.

The full text of the EU declaration of conformity is available at the following Internet address: https://wiki.teltonika- networks.com/view/RUTX10_CE/RED

Instruction Manual: Connect the power adapter to turn on the device. Open 192.168.1.1 in your web browser to conﬁgure it. More information on https://wiki.teltonika-networks.com/

www.teltonika-networks.com