Vidami Studio One Mode and Functions User Guide
- June 12, 2024
- Vidami
Table of Contents
Studio One Mode and Functions
User Guide
STUDIO
ONE MODE & FUNCTIONS GUIDE (PC)
STUDIO ONE MODE
To switch to STUDIO ONE MODE, place Vidami Blue on a flat surface and HOLD Loop
and Forward as you TAP Back. The blue LED will blink 3 times to show that you
successfully changed modes.
STUDIO ONE MODE FUNCTIONS
NOTE
To check which mode your Vidami Blue is in, open a blank document on your
computer or iOS device and place cursor on document. On the Vidami Blue, HOLD
Speed and Forward as you TAP Play/Pause. The blue LED will blink 3 times and
the name of the current mode will print out on your document.
STUDIO ONE KEYBOARD SHORTCUT SETUP
In order to optimize the use of your Vidami Blue, the following settings need
to be configured.
Keyboard Shortcut Seup
Under the Studio One menu:
Select Preferences, General, Keyboard Shortcuts.
In the search bar, enter Duplicate. Under Track, select Duplicate. Next click
inside the “Enter Key:”
window bar on the right. With this window bar selected, Hold the Forward
switch on the Vidami Blue.
This action will enter the proper key command. Next, click the Assign button
to confirm the keyboard shortcut. Click the Apply button at the bottom to
confirm the keyboard shortcut.
Next, enter “Forward Bar” in the search bar. Under Transport, select Forward
Bar.
Next click inside the “Enter Key:” window bar on the right. With this window
bar selected, Tap the Loop switch on the Vidami Blue. Next, click the Assign
button to assign the command, then Click the Apply button at the bottom to
confirm the keyboard shortcut.
Next, enter “Rewind Bar” in the search bar.
Under Transport, select Rewind Bar.
Next click inside the “Enter Key:” window bar on the right. With this window
bar selected, Tap the Speed switch on the Vidami Blue. Next, click the Assign
button to assign the command, then Click the Apply button at the bottom to
confirm the keyboard shortcut. Click OK to save and close the preferences
window.
(Navigation: Studio One menu/Preferences/General/Keyboard Shortcuts)
Audio Input Follows Selection
Under the Studio One menu:
Select Preferences, Advanced, Console. Enable “Audio Input Follows Selection”
. Click Apply, then Click OK to save and close the preferences window.
(Navigation: Studio One menu/Preferences/Advanced/Console)