Teltonika RUT955 Industrial Dual SIM 4G LTE and WiFi Cellular Router User Guide

Teltonika RUT955 Industrial Dual SIM 4G LTE and WiFi Cellular Router

OVERVIEW

FRONT VIEW

BACK VIEW

POWER SOCKET PINOUT

HARDWARE INSTALLATION

1. Push the SIM holder button with the SIM needle.
2. Pull out the SIM holder.
3. Insert your SIM card into the SIM holder.
4. Slide the SIM holder back into the router.
5. Attach mobile, WiFi and GNSS antennas.
6. Connect the power adapter to the socket on the front of the device. Then plug the other end of the power adapter into a power outlet.
7. Connect to the device wirelessly (SSID: RUT955_**** (unique to each device)) or use an Ethernet cable (connected to LAN port).

LOGIN TO DEVICE

1. To enter the router’s Web interface (WebUI), type http://192.168.1.1 into the URL field of your Internet browser.
2. Use login information shown in image A when prompted for authentication.
3. After you login, you will be prompted to change your password for security reasons. The new password must contain at least 8 characters, including at least one uppercase letter, one lowercase letter and one digit. This step is mandatory and you will not be able to interact with the router’s WebUI before you change the password.
4. When you change the router’s password, the Configuration Wizard will start. The Configuration Wizard is a tool used to setup some of the router’s main operating parameters.
5. Go to the Status > Network page and pay attention to the Signal Strength indication (image B). To maximize the cellular performance try adjusting the antennas or changing the location of your device to achieve the best signal conditions.

TECHNICAL INFORMATION

Radio specifications

RF technologies| GSM, GPRS, EDGE, UMTS/HSPA+, LTE, GNSS, WiFi
Max RF power| 33 dBm@GSM, 24 dBm@WCDMA, 23 dBm@LTE, 20 dBm@WiFi
**Bundled antennas specifications*
GSM/WCDMA/LTE antenna| 698~868/1850~2690 MHz, 50 Ω, VSWR<2, gain 2 dBi, omnidirectional, SMA male connector
WiFi antenna| 2400~2483.5 MHz, 50 Ω, VSWR<2, gain 2 dBi, omnidirectional, RP-SMA male connector
GNSS antenna| 1575.42~1602 MHz, 2.2~5 VDC, VSWR<1.5, gain 28 dB (typ.), RHCP polarization, SMA male connector

Order code dependent.
Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for compliance with the legal regulations.

SAFETY INFORMATION

RUT955 router must be used in compliance with any and all applicable national and international laws and with any special restrictions regulating the utilization of the communication module in prescribed applications and environments.

Hereby, TELTONIKA declares that this RUT955 is in compliance with the essential requirements and other relevant provisions of Directive CE/RED.

Instruction Manual: Connect the power adapter to turn on the device. Open 192.168.1.1 in your web browser to configure it. More information on https://wiki.teltonika.lt.

This sign on the package means that all used electronic and electric equipment should not be mixed with general household waste.
Hereby, Teltonika declares that the radio equipment type RUT955 is in compliance with Directives: 2014/53/EU, 2014/35/EU, 2014/30/EU. The full text of the EU declaration of conformity is available at the following internet address: https://teltonika.it/product/rut955/

www.teltonika.lt

References

• Teltonika | Wiki Knowledge Base

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>