OXFORD OX747 Super Wonder Bar Strap Tie-Down Instructions
- June 3, 2024
- OXFORD
Table of Contents
OXFORD OX747 Super Wonder Bar Strap Tie-Down
Safe working Load: 72kg
HOW TO USE
- Load motorcycle into van/trailer, placing front wheel against a secure stop.
- Place machine on side/centre/paddock stand or get second person to hold the machine until secure.
- Grasp the two red cuffs, one in each hand and pull apart far enough to slip the cuffs over each grip being careful not to foul any switch gear or levers.
- Cip carabiners to the trailer anchor points/strapping points and pul the webbing strap to tighten until secure. To prevent slippage of the strap through the cam buckle, tie off the strap ends around the strap and make a knot.
NOTE:
Additional tie-downs are required to secure the rear of the motorcycle. Make
sure that the anchor points are slightly forward of the front wheel stop. The
tie-down points should always be as far apart as possible to triangulate the
support of your bike. It would be advisable to cable tie the front brake lever
to the handlebar grip or to Use the Oxford Clamp-On to ensure the bike cannot
roll forward. It may also be advisable to secure the wheel to the
floor/trailer to stop lateral slippage.
WARNING:
THE USER OF THE OXFORDBAR STRAP HARNESS ASSUMES FULL RESPONSIBILITY FOR
DETERMINING THE SAFETY AND SUITABILITY OF THIS DEVICE AND LIABILITY IS
THEREFORE LIMITED TO THE REPLACEMENT OF THE BAR STRAP IF PROVEN TO BE
DEFECTIVE IN WORKMANSHIP OR MATERIALS.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>