oxford BABY 22288 Universal 4 In 1 Convertible Crib Full Bed Conversion Kit Instruction Manual

October 30, 2023
oxford BABY

BABY 22288 Universal 4 In 1 Convertible
Crib Full Bed Conversion Kit

Instruction Manual

oxford BABY 22288 Universal 4 In 1 Convertible Crib Full Bed Conversion Kit
ASSEMBLY INSTRUCTIONS
for Full Bed Conversion Kit

“RECOMMENDATION: We recommend the use of a Bunkie Board or box spring under a mattress for this conversion kit.
Thank you for your purchase!
Remove all parts and hardware from the box and lay on a carpeted or scratch -free work surface.
Do not dispose of any contents until assembly is completed.
Familiarize yourself with all exhibits and diagrams to facilitate the assembly of your crib.

TOOLS REQUIRED:

![oxford BABY 22288 Universal 4 In 1 Convertible Crib Full Bed Conversion Kit

PARTS ENCLOSED IN CARTON

![oxford BABY 22288 Universal 4 In 1 Convertible Crib Full Bed Conversion Kit

HARDWARE

![oxford BABY 22288 Universal 4 In 1 Convertible Crib Full Bed Conversion Kit

Do not fully tighten all bolts until all parts are in place.
(please add an extra 1/2 revolution to the bolts when using spring washer after tightening)

ASSEMBLY OF HEADBOARD AND FOOTBOARD

THIS STEP REQUIRES:
Head Board (1 pc)
Foot Board (1 pcs)
A. Rail (2 pcs)

![oxford BABY 22288 Universal 4 In 1 Convertible Crib Full Bed Conversion Kit

STEP 1.1
Place Headboard in vertical position and then hook rails (A} to Headboard.

STEP 1.2
Place Footboard in vertical position and then hook rails (A) to Footboard

ASSEMBLY OF SLATS

THIS STEP REQUIRES : B. Slat (5 pcs)

![oxford BABY 22288 Universal 4 In 1 Convertible Crib Full Bed Conversion Kit

(C) Allen Bolt 1″(25 mm) (2 pcs)(D) Screw 1 1/4″(30 mm) (10 peg) Nut 3 / 4 ” (20mm) (2 pcs)

![oxford BABY 22288 Universal 4 In 1 Convertible Crib Full Bed Conversion Kit

![oxford BABY 22288 Universal 4 In 1 Convertible Crib Full Bed Conversion Kit

STEP 2
– After attaching Rails (A) to headboard and footboard, place Slat (B) on the support strip of Rail (A), fasten both ends of Slat (B) with screw (D).
Tighten all Screws by Screw Driver (unsupplied).

STEP 3
– Insert Allenol 1″ (25 mm) (C), through the top hole in the headboard from the inside and connect with nut 3/4″ (20 mm) (E).
Tighten all bolts and nuts with Allen key (F). Assembly complete. Thanks you!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals