SDC FALCON Electric Latch Retraction Kit LR100FAK Instruction Manual
- June 6, 2024
- SDC
Table of Contents
SDC FALCON Electric Latch Retraction Kit LR100FAK
Remove Push Bar. Remove Dogging Assembly. Slide the ELR unit into the device base. Align the first set of two holes over the two base unit holes and attach with the two #10-32 flat head screws supplied. Attach the Linkage to the device as shown. Re-attach the Push Bar.
When retrofitting to existing vertical rod devices, adjustment of the rods is required for proper operation of the Electric Latch Retractor. Once the unit is properly installed, energize it so the push pad is dogged down, then reconnect the vertical rods to the device and make the proper adjustments.
USE TEMPLATE WHEN DEVICES ARE LONGER THAN 36″ FOR ADDED STABILITY OF KIT.
ALIGN TEMPLATE TO EXISTING HOLES, FALCON/DOR-O-MATIC or FIRST CHOICE. MARK AND
DRILL 1 HOLE
FOR 10-32 FLT HD
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>