SDC 3327A Electric Latch Retraction Device Kit Installation Guide
- May 15, 2024
- SDC
Table of Contents
SDC 3327A Electric Latch Retraction Device Kit
INSTALLATION INSTRUCTIONS
Retrofit Installation Note: 42″ or 48″ exit devices that have been modified to fit a 36″ or smaller opening, may not have the required space to fit the standard E. L. R. assembly. Always verify the distance from the end of the touchpad to the end rail, and if necessary, consult with the factory for appropriate selection.
ELECTRICAL DATA
24VDC +/- 10%1.5A Inrush / 200mA holding RED (+) BLK (-)PATENT #8,851,530
- Visit: sdcsec.com/vonduprin For Installation video
Step 1
Remove Von Duprin installed mechanical dogging assembly.
Step 2
Slide the LR100 Electric Latch Retraction assembly into device and attach the
linkage to the latch retraction rod.
Step 3
Tighten set screws.
LR-1VD CONNECTING RODFOR USE ON VON DUPRIN DEVICESLESS DOGGING FEATURE
When retrofitting to existing vertical rod devices, adjustment of the rods are
required for proper assembly of the LR100VDK Kit.
Please see the SDC website (www.sdcsecurity.com)
for installation tips and photographs of installing.
- Remove the rail and push pad from the device
- Drill a 5/32″ (.156″) diameter hole as shown in illustration.
- Insert the connecting rod provided and fasten in screw
36″ OPENING FULL LENGTH 36″ DEVICE
NOTE Retro-Fitting Vertical Rod Devices:
Before retro-fitting an electric latch assembly into a vertical device, the
following must be done to ensure proper alignment. Disconnect the vertical
rods from the device head. Install the electric latch assembly as shown above.
Once the ELR is properly installed energize it so that the push pad is dogged
down, by doing so it will allow for proper alignment for the vertical rods.
Finally reconnect the vertical rods to the device and make the proper
adjustments.
CUSTOMER SUPPORT
[t] 800.413.8783
805.494.0622
E-mail: service@sdcsecurity.com
801 Avenida Acaso, Camarillo, CA 93012
PO Box 3670, Camarillo, CA 93011